Toyota Corolla Cross: Can Communication System (for Gasoline Model)
Toyota Corolla Cross (2022-2024) Service Manual / Power Source & Network / Networking / Can Communication System (for Gasoline Model)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Utility
- Terminals Of Ecu
- Diagnosis System
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Central Gateway ECU System Internal Failure (B102004)
- Lost Communication with Brake System Control Module (ch2) Missing Message (U117087)
- Check CAN Communication Connection
- Skid Control ECU Communication Stop Mode
- Clearance Warning ECU Communication Stop Mode
- Air Conditioning Amplifier Communication Stop Mode
- Power Steering ECU Communication Stop Mode
- Steering Angle Sensor Communication Stop Mode
- ECM Communication Stop Mode
- Transmission Control ECU Communication Stop Mode
- Main Body ECU Communication Stop Mode
- Combination Meter ECU Communication Stop Mode
- Certification ECU Communication Stop Mode
- Center Airbag Sensor Communication Stop Mode
- Headlight ECU RH Communication Stop Mode
- Engine Stop and Start ECU Communication Stop Mode
- 4WD Control ECU Communication Stop Mode
- Radio Receiver Assembly Communication Stop Mode
- Blind Spot Monitor Sensor Communication Stop Mode
- Bus Buffer ECU Communication Stop Mode
- DCM Communication Stop Mode
- Power Back Door ECU Communication Stop Mode
- Millimeter Wave Radar Sensor Communication Stop Mode
- Rear Television Camera Communication Stop Mode
- Front Camera Module Communication Stop Mode
- Tire Pressure Monitor ECU Communication Stop Mode
- Check Bus 1 Line
- Check Bus 2 Line
- Check Bus 3 Line
- Check Bus 4 Line
- Check Bus 5 Line
- Check Bus 6 Line
- Check Bus 7 Line
READ NEXT:
Precaution
PRECAUTION
PRECAUTION WHEN REPLACING CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)
(a) When the central gateway ECU (network gateway ECU) is replaced, update the
ECU security key.
Click here
PRECA
Parts Location
PARTS LOCATION
ILLUSTRATION
*1
FORWARD RECOGNITION CAMERA
*2
ECM
*3
BRAKE ACTUATOR ASSEMBLY
*4
HEADLAM
System Diagram
SYSTEM DIAGRAM
OVERALL CAN BUS DIAGRAM
*A
w/ Parking Assist Monitor System
*B
w/o Parking Assist Monitor System
CAN Main Bus L
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. CONNECT GTS
(a) Connect the GTS to the DLC3 with the engine switch off.
(b) Start the engine and run it at idle.
(c) Turn the GTS on.
(d) Enter the following menus: Chassis / Brake/EPB / Active Test.
HINT:
Refer to the GTS operator's manual for further
Outside Vehicle
OUTSIDE VEHICLE
These are maintenance and inspection items that are considered to be the
owner's responsibility.
The owner can do them or they can have them done at a service center.
These items include those that should be checked on a daily basis, those
that in most cases do not
© 2020-2024 Copyright www.tcorollacross.com
