Toyota Corolla Cross: Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
DATA LIST
(a) Read the Data List.
Body Electrical > Central Gateway > Data List|
Tester Display |
|---|
|
Total Distance Traveled |
|
Total Distance Traveled - Unit |
|
IG2 SW/IGR SW |
|
IG1 SW/IGP SW |
|
ACC SW |
|
+B Voltage |
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
|---|---|---|---|
|
Total Distance Traveled |
Total distance traveled |
Min.: 0 km (0 mile), Max.: 16777215 km (10425361 mile) |
- |
|
Total Distance Traveled - Unit |
Total Distance Traveled unit |
km or mile |
- |
|
IG2 SW/IGR SW |
Ignition switch ON signal (IGR terminal) |
OFF or ON |
OFF: Ignition switch ACC or off ON: Ignition switch ON |
|
IG1 SW/IGP SW |
Ignition switch ON signal (IGP terminal) |
OFF or ON |
OFF: Ignition switch ACC or off ON: Ignition switch ON |
|
ACC SW |
Ignition switch ACC signal (ACC terminal) |
OFF or ON |
OFF: Ignition switch off ON: Ignition switch ACC or ON |
|
+B Voltage |
Auxiliary battery voltage (BATT terminal) |
Over 8 V or Under 8 V |
Over 8 V: Auxiliary battery voltage 8 V or higher Under 8 V: Auxiliary battery voltage below 8 V |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Diagnostic Trouble Code Chart
DTC No.
Detection Item
Trouble Area
Link
B102004
Central Gateway E
Central Gateway ECU System Internal Failure (B102004)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
DTC Output from
Priority
Note
B10
Lost Communication with Brake System Control Module (ch2) Missing Message (U117087)
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
U117087
Lost Communication with Brake S
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Before installing the rear center seat outer belt assembly, check the ELR function.
NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled
ABS Malfunction (C1296)
DESCRIPTION
When a malfunction has occurred in the speed sensor circuit or the yaw rate and
acceleration sensor circuit, the 4WD ECU assembly stores DTC C1296.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1296
