Toyota Corolla Cross: Meter / Gauge System
Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System
- Precaution
- Parts Location
- System Diagram
- How To Proceed With Troubleshooting
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Lost Communication with EMV Missing Message (B132187)
- Fuel Sender Circuit Open (B150013,B150113)
- Turn Signal Light Circuit Current Below Threshold (B150718)
- Turn Signal/Hazard Flasher Circuit Current Above Threshold (B150819)
- Lost Communication With ECM/PCM "A" Missing Message (U010087,...,U113387)
- Entire Combination Meter does not Operate
- Speedometer Malfunction
- Tachometer Malfunction
- Fuel Receiver Gauge Malfunction
- Engine Coolant Temperature Receiver Gauge Malfunction
- Hybrid System Indicator Malfunction
- Operating Light Control Rheostat does not Change Light Brightness
- Steering Pad Switch Circuit
- Engine Oil Level Sensor Circuit
- Speed Signal Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE (-) AUXILIARY BATTERY TERMINAL
NOTICE:
After the ignition switch is turned off, there may be a waiting time before disconnecting the n
Parts Location
PARTS LOCATION ILLUSTRATION
*A for Gasoline Model
*B w/ Washer Fluid Level Warning System
*1 ECM
*2 BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY
- BRAKE FLUID LEV
System Diagram
SYSTEM DIAGRAM HINT: Refer to System Diagram of CAN Communication System.
for HEV Model:
Click here
for Gasoline Model:
Click here
COMBINATION METER ASSEMBLY DIAGRAM
TURN SIGNAL
SEE MORE:
Fuel Rail / System Pressure - Too High (P008800)
DESCRIPTION Refer to DTC P008700. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P008800 Fuel Rail / System Pressure - Too High
Although the ECM is requesting the fuel pump assembly (for high pressure side) to open the spill
Intermediate Shaft Speed Sensor "B" Circuit Short to Battery (P274512,P274514,P274531)
DESCRIPTION
The transmission revolution sensor (NC1) detects the intermediate shaft (C1 clutch)
speed and sends it to the TCM.
The TCM determines if gear mode should be entered by comparing the transmission
revolution sensor (NT) and (NC1) signals.
DTC No.
Detection Item
© 2020-2025 Copyright www.tcorollacross.com
