Toyota Corolla Cross: Customize Parameters
Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Meter / Gauge / Display / Meter / Gauge System / Customize Parameters
CUSTOMIZE PARAMETERS
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
CUSTOMIZE METER / GAUGE SYSTEM
(a) Customizing with the GTS
(1) Select the setting by referring to the table below.
Warning|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Flasher Sound Volume Adjust |
Function to change the turn signal flasher buzzer sound volume |
Medium | $02:Large,$00:Medium,$01:Small |
Combination meter assembly |
|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| ODO Display Time After IG OFF Adjust |
Function to change the trip result display time after the ignition switch is turned off |
30s | $00:30s,$01:60s,$02:600s,$03:OFF |
Combination meter assembly |
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the info
Terminals Of Ecu
TERMINALS OF ECU COMBINATION METER ASSEMBLY
(a) Measure the voltage and resistance according to the value(s) in the table below.
Terminal No. (Symbol) Terminal Description
Condition
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
SEE MORE:
Rough Idling
DESCRIPTION
Problem Symptom Suspected Area
Trouble Area
Engine speed fluctuation due to abnormal combustion
Idle speed too low or high
Strong engine vibration due to above symptoms
Ignition malfunction
Deviation in air fuel ratio (Excessive or i
Operation Check
OPERATION CHECK CHECK ELECTRICAL REMOTE CONTROL MIRROR FUNCTION
(a) Turn the ignition switch to ON. (b) With L on the mirror select and mirror adjust switch selected, check that the outer rear view mirror assembly LH surface moves up, down, left and right normally.
(c) With R on the mirror select
© 2020-2025 Copyright www.tcorollacross.com
