Toyota Corolla Cross: Do-it-yourself maintenance
Toyota Corolla Cross (2022-2024) Owner's Manual / Maintenance and care / Do-it-yourself maintenance
- Do-it-yourself service precautions
- Hood
- Positioning a floor jack
- Engine compartment
- Adding engine oil
- Checking the engine coolant
- Battery
- Adding the washer fluid
- Tires
- Tire pressure warning system
- Installing tire pressure warning valves and transmitters
- Registering ID codes
- Selecting wheel set
- Tire inflation pressure
- Wheels
- Air conditioning filter
- Wireless remote control/electronic key battery
- Checking and replacing fuses
- Headlight aim
- Light bulbs
READ NEXT:
Do-it-yourself service precautions
If you perform maintenance
by yourself, be sure to follow
the correct procedure
as given in these sections.
Maintenance
WARNING
The engine compartment contains
many mechanisms and fluids that
may m
Hood
Opening the hood
1. Pull the hood lock release
lever.
The hood will pop up slightly.
2. Pull the auxiliary catch lever
to the left and lift the hood.
3. Hold the hood open by inserting
the support
Positioning a floor jack
When using a floor jack, follow
the instructions in the
manual provided with the
jack and perform the operation
safely.
When raising your vehicle
with a floor jack, position
the jack correctly. Impro
SEE MORE:
Right Front Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open
(C14E314)
DESCRIPTION
Refer to DTC C050612
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
DTC Output from
Note
C14E314
Right Front Wheel Speed Sensor Supply Voltage Circuit
Knock Sensor 1 Bank 1 or Single Sensor Circuit Short to Battery or Open (P032515)
DESCRIPTION Refer to DTC P032511. Click here
HINT: When DTC P032515 is stored, the ECM enters fail-safe mode. During fail-safe mode, the ignition timing is delayed to its maximum retardation. Fail-safe mode continues until the ignition switch is turned off.
DTC No. Detection Item
DT
© 2020-2024 Copyright www.tcorollacross.com
