Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Lost Communication with Hybrid/EV Powertrain Control Module (ch6) Missing Message (U11BC87)

Toyota Corolla Cross (2022-2025) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hybrid Control System / Lost Communication with Hybrid/EV Powertrain Control Module (ch6) Missing Message (U11BC87)

DESCRIPTION

The hybrid vehicle control ECU transmits and receives signals via CAN communication to and from the No. 2 skid control ECU (brake actuator assembly).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

Note

U11BC87

Lost Communication with Hybrid/EV Powertrain Control Module (ch6) Missing Message

No. 2 skid control ECU (brake actuator assembly) cannot receive signals from the hybrid vehicle control ECU

  • No. 2 skid control ECU (brake actuator assembly)
  • Hybrid vehicle control ECU
  • Wire harness or connector

Does not come on

Master Warning:

Does not come on

SAE Code:

U11BC

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click here

  1. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  2. Turn the ignition switch off and wait for 2 minutes or more.
  3. Turn the ignition switch to ON and wait for 2 minutes or more.
  4. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
  5. Check the DTC judgment result.

    HINT:

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform the normal judgment procedure again.

PROCEDURE

1.

GO TO CAN COMMUNICATION SYSTEM

Click here

NEXT

END

    READ NEXT:

     Brake Override System

    DESCRIPTION When the vehicle is being driven with the accelerator pedal depressed, depressing the brake pedal without releasing the accelerator pedal will activate the brake override system to restric

     Transmission Control Switch Circuit

    DESCRIPTION When the shift lever is in S, different ranges can be chosen using the floor shift sequential gate. WIRING DIAGRAM Refer to the wiring diagram for the shift paddle switch circuit. (w/ S

     Shift Paddle Switch Circuit

    DESCRIPTION Moving the shift lever to S enables the shift range to be selected. The shift range can be selected by operating the "+" or "-" shift paddle switch. WIRING DIAGRAM CAUTION / NOTICE / H

    SEE MORE:

     Low Pressure Fuel System Pressure - Too Low (P008A00)

    DESCRIPTION In order to supply the optimal fuel pressure according to the driving conditions and usage environment, the variable fuel system sends a drive signal from the ECM to the fuel pump control ECU, steplessly performing variable control of the fuel pump (for low pressure side) and receiving f

     Inspection

    INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame. (a) Check that the float moves smoothly between F and E. (b) Check the fuel sender gauge assembly voltage. (1) Apply 5 V b

    © 2020-2025 Copyright www.tcorollacross.com