Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received (U042481)

Toyota Corolla Cross (2022-2024) Service Manual / Engine & Hybrid System / Hybrid / Battery Control / Hybrid Control System / HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received (U042481)

DESCRIPTION

If the hybrid vehicle control ECU receives an invalid compressor control request from the air conditioning amplifier assembly via CAN communication, it will store this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

Note

U042481

HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received

An invalid control request was received from the air conditioning amplifier assembly

(1 trip detection logic)

Air conditioning amplifier assembly

Does not come on

Master Warning:

Does not come on

SAE Code:

U0424

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTCs and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click here

  1. Connect the GTS to the DLC3.
  2. Turn the ignition switch to ON and turn the GTS on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the ignition switch off and wait for 2 minutes or more.
  5. Turn the ignition switch to ON and turn the GTS on.
  6. Wait for 1 minute or more with the vehicle stopped, the ignition switch to ON (READY), the shift lever in P and the air conditioning system on (Lo/COOL MAX, blower speed HI).
  7. Turn the air conditioning system off and wait for 10 seconds or more with the ignition switch ON (READY).
  8. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
  9. Check the DTC judgment result.

    HINT:

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE, perform driving pattern again.

PROCEDURE

1.

CHECK DTC OUTPUT (AIR CONDITIONER)

(a) Check if DTCs related to the Air Conditioning System (A/C) are output.

Body Electrical > Air Conditioner > Trouble Codes
Result

Proceed to

DTCs related to Air Conditioning System (A/C) are not output.

A

DTCs related to Air Conditioning System (A/C) are output.

B

(b) Turn the ignition switch off.

A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

GO TO DTC CHART (AIR CONDITIONING SYSTEM)

    READ NEXT:

     Lost Communication with Drive Motor Control Module "A" (ch4) Missing Message (U117E87)

    DESCRIPTION The hybrid vehicle control ECU transmits and receives signals via CAN communication to and from the inverter with converter assembly (MG ECU). DTC No. Detection Item DTC Det

     Lost Communication with Hybrid/EV Powertrain Control Module (ch6) Missing Message (U11BC87)

    DESCRIPTION The hybrid vehicle control ECU transmits and receives signals via CAN communication to and from the No. 2 skid control ECU (brake actuator assembly). DTC No. Detection Item

     Brake Override System

    DESCRIPTION When the vehicle is being driven with the accelerator pedal depressed, depressing the brake pedal without releasing the accelerator pedal will activate the brake override system to restric

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 FRONT AXLE ASSEMBLY - - - - 2 FRONT LOWER BALL JOINT ASSEMBLY

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE NOTICE: The following inspection procedures for the parking assist monitor system are based on the assumption that the audio and visual system is normal. If the audio and visual system has any malfunction, first proceed with troubleshooting of the audio and vi

    © 2020-2024 Copyright www.tcorollacross.com