Toyota Corolla Cross: Driving procedures
Toyota Corolla Cross (2022-2025) Owner's Manual / Driving / Driving procedures
- Engine (ignition) switch (vehicles without a smart key system)
- Changing the engine switch positions
- Engine (ignition) switch (vehicles with a smart key system)
- Stopping the engine
- Changing engine switch modes
- Continuously variable transmission
- Turn signal lever
- Parking brake
- Brake Hold
READ NEXT:
Engine (ignition) switch (vehicles
without a smart key system)
Starting the engine
1. Check that the parking brake
is set.
2. Check that the shift lever is in
P.
Do not press the shift lever button
after shifting the shit position to P.
3. Firmly depress the b
Changing the engine
switch positions
OFF ("LOCK" position)
The key can be removed. (The key
can be removed only when the shift
lever is in P.)
ACC ("ACC" position)
Some electrical components such
as the audio system can be used.
Engine (ignition) switch (vehicles
with a smart key system)
Performing the following
operations when carrying
the electronic key on your
person starts the engine or
changes engine switch
modes.
Starting the engine
1. Check that the parking brake
is set.
2. C
SEE MORE:
Engine/Power Switch Signal Compare Failure (B227862)
DESCRIPTION This DTC is stored when the SSW1 contact signal, SSW2 contact signal and SSW3 contact signal, which are detected when the ignition switch is operated, do not match.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Note B227862
Engine/Power Switch
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
(a) Disconnect the T12 sliding roof ECU (sliding roof drive gear sub-assembly) connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
HINT: Measure the values on the wire harne
© 2020-2025 Copyright www.tcorollacross.com
