Toyota Corolla Cross: Utility
UTILITY
ALL READINESS
(a) Power Distribution Box Assembly
Body Electrical > Power Distribution Box > Utility
|
Tester Display
|
|
All Readiness
|
READ NEXT:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of the problem symptom. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in orde
TERMINALS OF ECU
NOTICE:
After the ignition switch is turned off, there may be a waiting time before
disconnecting the negative (-) auxiliary battery terminal.
Click here
When disconn
DATA LIST / ACTIVE TEST
READ DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when d
SEE MORE:
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate that the current sensor value is abnormal. The cause of this malfunction may be one of the following: Internal inverter malfunction
Inverter with converter assembly internal circuit malfunction
Inverter low-voltage circuit malfunctio
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection.
Therefore, be sure to clear the DTCs using the GTS once the inspection has
been completed.
Do not apply excessive force to the forward recognition camera connector.
CHECK FORWARD
Problem Symptoms Table
Generator Phase U Current Sensor Circuit Short to Battery (P0E0012,P0E0014,P0E001F,P0E0412,P0E0414,P0E041F,P0E0812,P0E0814,P0E081F)
