Toyota Corolla Cross: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
CAUTION / NOTICE / HINT
NOTICE:
Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.
PROCEDURE
|
1. |
CHECK SATELLITE RADIO |
(a) Check radio condition.
|
Result |
Proceed to |
|---|---|
|
Broadcast cannot be selected. |
A |
|
Broadcast can be selected, but selection cannot be memorized. |
B |
| A | .gif)
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
.gif)
|
2. |
CHECK SATELLITE RADIO |
(a) Check the number of preset channels.
OK:
36 channels have already been preset.
| OK |
|
END (ONLY 36 CHANNELS CAN BE PRESET) |
|
|
3. |
CHECK AUXILIARY BATTERY |
(a) Check if the auxiliary battery was replaced.
OK:
Auxiliary battery was not replaced.
| OK |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
|
|
4. |
ADD PRESET CHANNEL INTO MEMORY AGAIN |
(a) Check if the preset channels that have been cleared can be added into memory again.
OK:
Preset channels can be added into memory.
| OK |
|
END |
| NG |
|
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
READ NEXT:
Radio Broadcast cannot be Received or Poor Reception
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection
or maintenance, performing initialization, registration or calibration may be needed.
Click here
Cellular Phone Registration Failure
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection
or maintenance, performing initialization, registration or calibration may be needed.
Click here
Cellular Phone Inspection
PROCEDURE
1.
CHECK USAGE CONDITIONS
(a) Check that the vehicle and cellular phone meet the following
conditions:
NOTICE:
If changing cellular phone settings, upda
SEE MORE:
Compressor Solenoid Circuit Short to Ground or Open (P06A014)
DESCRIPTION In this circuit, the compressor with pulley assembly receives refrigerant compression demand signals from the air conditioning amplifier assembly.
Based on this signal, the compressor with pulley assembly changes the amount of compressor output.
DTC No. Detection Item
DTC
Cancellation of 4WD Control (C1299)
DESCRIPTION
While driving, if the heat generated by the transmission coupling assembly exceeds
a certain amount or if the estimated oil temperature of the transfer exceeds a certain
amount, the 4WD ECU assembly cancels 4WD control and stores DTC C1299.
DTC No.
Detection I
