Toyota Corolla Cross: Removal

REMOVAL

CAUTION / NOTICE / HINT

Procedure		Part Name Code
1	TIMING CHAIN COVER ASSEMBLY	11310	-	-	-
2	OIL PAN SUB-ASSEMBLY	12101		-	-
3	OIL STRAINER SUB-ASSEMBLY	15104		-	-
4	ENGINE OIL LEVEL SENSOR	89491		-	-
5	ENGINE BALANCER ASSEMBLY	-		-	-
6	OIL PUMP ASSEMBLY	15100	-	-	-
7	STIFFENING CRANKCASE ASSEMBLY	11420		-	-

CAUTION / NOTICE / HINT

NOTICE:

• After the ignition switch is turned off, the navigation system records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 3 minutes before disconnecting the cable from the negative (-) battery terminal.
• When the cable is disconnected from the negative (-) auxiliary battery terminal and the security lock setting has been enabled, multi-display operations will be disabled upon next startup unless the password is entered. Be sure to check the security lock setting before disconnecting the cable from the negative (-) auxiliary battery terminal.

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

• Learning completes when vehicle is driven

  Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
  Front Camera System	Drive the vehicle straight ahead at 15 km/h (10 mph) or more for 1 second or more.

• Learning completes when vehicle is operated normally

  Effect/Inoperative Function When Necessary Procedures are not Performed	Necessary Procedures	Link
  Power door lock control system Back door opener	Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch.
  Power back door system	Fully close the back door by hand. HINT: Initialization is not necessary if the above procedures are performed while the back door is closed.
  Air conditioning system	After the ignition switch is turned to ON, the servo motor standard position is recognized.	-

PROCEDURE

1. REMOVE TIMING CHAIN COVER ASSEMBLY

Click here

2. REMOVE OIL PAN SUB-ASSEMBLY

Click here

3. REMOVE OIL STRAINER SUB-ASSEMBLY

Click here

4. REMOVE ENGINE OIL LEVEL SENSOR

Click here

5. REMOVE ENGINE BALANCER ASSEMBLY

Click here

6. REMOVE OIL PUMP ASSEMBLY

7. REMOVE STIFFENING CRANKCASE ASSEMBLY

Click here

READ NEXT: