Toyota Corolla Cross: Fuel System
READ NEXT:
Precaution
PRECAUTION
CAUTION:
Never perform work on fuel system components near any possible ignition sources.
Vaporized fuel could ignite, resulting in a serious accident.
Do not perform work
Parts Location
PARTS LOCATION ILLUSTRATION
*A for 2WD
- -
*1 ECM
*2 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 ENGINE ROOM JUNCTION BLOCK
- IG2 NO. 1 RELAY - EFI-MAIN NO. 2 REL
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. CHECK FUEL PUMP OPERATION AND INSPECT FOR FUEL LEAK (a) Check fuel pump operation.
(1) Connect the GTS to the DLC3. (2) Turn the ignition switch to ON.
NOTICE:
SEE MORE:
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
input shaft type T oil seal removal/installation are shown below.
Necessary Procedures After
Power Distribution Box Missing Message (B235587,B235787-B235987)
DESCRIPTION
This DTC is stored when CXPI communication between the power distribution box
assembly and windshield wiper relay assembly, headlight assembly RH*1, headlight
assembly LH*1 or main body ECU (multiplex network body ECU) stops for 10 seconds
or more.
*1: for LED Type Parking Lig
© 2020-2024 Copyright www.tcorollacross.com
