Toyota Corolla Cross: Drive Shaft System
Precaution
PRECAUTION
NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (for M20A-FKS AWD)
(a) When removing and installing the front drive shaft assembly RH, be sure to first drain all the transaxle oil and transfer oil. If removal and installation are carried out without draining these oils, the transfer oil will flow into the transaxle side. Extensive cleaning will be required if the two oils mix.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
Front wheel shimmy |
Front drive shaft (worn) (for M20A-FKS 2WD) |
|
|
Front drive shaft (worn) (for M20A-FKS AWD) |
|
|
|
Front drive shaft (worn) (for M20A-FXS) |
|
|
|
Rear wheel shimmy |
Rear drive shaft (worn) (for M20A-FKS) |
|
|
Rear drive shaft (worn) (for M20A-FXS) |
|
.gif)
READ NEXT:
Removal
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
FRONT WHEELS
-
-
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
COMPONENTS (DISASSEMBLY)
Procedure
Part Name Code
1
FRONT NO. 2 AXLE INBOARD JOINT
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT: Using the GTS to read the Data List allows the values or states o
Inspection
INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY LH
(a) Parking brake actuator assembly LH operation inspection
(1) Apply voltage to the terminals of the parking brake actuator
assembly LH and check that it operates as specified.
OK:
Tester C
