Toyota Corolla Cross: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Read the Data List according to the display on the GTS.
Body Electrical > Main Body > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Actual driven distance |
0 to 16777215 | Roughly the same as the actual driven distance |
- |
| Total Distance Traveled - Unit |
Actual driven distance unit |
km or mile | Displays the current actual driven distance unit |
- |
| Auto High Beam Main Switch |
Auto high beam switch signal |
OFF or ON | OFF: Auto high beam switch not pressed ON: Auto high beam switch pressed |
- |
| Light Control Switch (HEAD) |
Light control switch head position signal |
OFF or ON | OFF: Light control switch not in head position ON: Light control switch in head position |
- |
| Insolation Amount of Solar Sensor RH |
Solar sensor RH condition |
0 to 51100 or Sensor Fail |
Condition can be displayed |
- |
| Insolation Amount of Solar Sensor LH |
Solar sensor LH condition |
0 to 51100 or Sensor Fail |
Condition can be displayed |
- |
| Light Sensor Illuminance |
Light control sensor illuminance |
0 to 8191 lx or Sensor Fail |
Value is output according to ambient light level |
The displayed value is "0" when no light is detected. |
|
AHS Function | AFS (adaptive front-lighting system) or adaptive high beam system control function |
Not Available or Available |
Not Available: AFS (adaptive front-lighting system) or adaptive high beam system control unavailable Available: AFS (adaptive front-lighting system) or adaptive high beam system control valid |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
|
High Beam Headlights (By AHS ECU) |
AFS (adaptive front-lighting system) or adaptive high beam system high beam operation status |
Light OFF or Light ON | Light OFF: AFS (adaptive front-lighting system) or adaptive high beam system high beam off Light ON: AFS (adaptive front-lighting system) or adaptive high beam system high beam on |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
|
Light Sensor Connection History |
Light control sensor connection status |
Without or With | Without: Automatic light control sensor has not been connected With: Automatic light control sensor connected or has been connected |
- |
| Headlight ECU Function |
ECU which controls the lighting system |
Not Available or Available |
Not Available: Headlight ECU system control unavailable Available: Headlight ECU system control valid |
- |
| LDM ECU Function |
Automatic high beam sensor current state |
Not Available or Available |
Not Available: LED driver module ECU system control unavailable Available: LED driver module ECU system control valid |
- |
| Automatic High Beam Headlights Sensor Detection Status |
Automatic high beam sensor state past 1 |
Undetected, N/A, No sens, Headlight, Taillight, Speed, Daytime, Village, Other sens, Change, Out of aim, SAE Mod, Aim adjust or LIN Err |
Condition can be displayed*2 |
- |
| IGR Power |
Ignition switch ON signal |
OFF or ON | OFF: Ignition switch off ON: Ignition switch ON |
- |
| Brightness Level Adjust (Canceling) |
Ambient brightness level required to cancel dimming display lights (combination meter, navigation display, etc.) |
Normal, Dark2, Dark1, Light1 or Light2 |
Customize setting displayed |
- |
| Sensitivity Adjust |
Sensitivity of the automatic light control system |
Normal, Dark2, Dark1, Light1 or Light2 |
Customize setting displayed |
- |
| DRL Function |
Turns the DRL function on/off. |
Enable | Customize setting displayed |
*1 |
| Light Auto OFF Delay Setting |
Keeps the headlights on for a certain period of time after turning the ignition switch off and closing all of doors with the low beam headlights on. |
30sec | Customize setting displayed |
- |
- *1: for vehicles with customize setting "DRL Function"
HINT:
*2: The details of each value of the Range are as follows:
|
Display Value | Condition |
Control Condition | Diagnostic Note |
|---|---|---|---|
|
Undetected | Automatic high beam sensor being initialized |
Control suspended (low beam headlights illuminated) |
- |
| N/A |
Automatic high beam sensor temporarily disabled due to high temperature, unclear image (due to dirt, fog, etc.), etc. |
Control suspended (previous beam setting maintained) |
- |
| No sens |
No lights detected and vehicle speed below operation speed |
High beam headlights illuminated |
Only when vehicle speed within operation speed range |
|
Headlight | Headlights of oncoming vehicle, etc. detected |
Low beam headlights illuminated |
Only when vehicle speed within operation speed range |
|
Taillight | Taillights preceding vehicle, etc. detected |
Low beam headlights illuminated |
Only when vehicle speed within operation speed range |
|
Speed | No lights detected and vehicle speed below operation speed |
Low beam headlights illuminated |
- |
| Daytime |
Bright light detected | Low beam headlights illuminated |
- |
| Village |
Streetlights, etc. detected |
Low beam headlights illuminated |
Only when vehicle speed within operation speed range |
|
Other sens | Not applicable |
- | - |
|
Change | Changing between low beams and high beams |
Changing between low beams and high beams |
Only when vehicle speed within operation speed range |
|
Out of aim | Not applicable |
- | - |
|
SAE Mod | Not applicable |
- | - |
|
Aim adjust | Not applicable |
- | - |
|
LIN Err | Not applicable |
- | - |
|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Actual driven distance |
0 to 16777215 | Roughly the same as the actual driven distance |
- |
| Total Distance Traveled - Unit |
Actual driven distance unit |
km or mile | Displays the current actual driven distance unit |
- |
| Light OFF Switch |
Light control switch off position signal |
OFF or ON | OFF: Light control switch not in off position ON: Light control switch in off position |
- |
| Auto Light Switch |
Light control switch AUTO position signal |
OFF or ON | OFF: Light control switch not in AUTO position ON: Light control switch in AUTO position |
- |
| Head Light Switch (Tail) |
Light control switch tail position signal |
OFF or ON | OFF: Light control switch in neither tail nor head position ON: Light control switch in tail or head position |
- |
| Head Light Switch (Head) |
Light control switch head position signal |
OFF or ON | OFF: Light control switch not in head position ON: Light control switch in head position |
- |
| High Beam Main Switch |
Dimmer switch high position signal |
OFF or ON | OFF: Dimmer switch not in high position ON: Dimmer switch in high position |
- |
| Passing Light Switch |
Dimmer switch high flash position (pass) signal |
OFF or ON | OFF: Dimmer switch not in high flash position ON: Dimmer switch in high flash position |
- |
| Auto High Beam Main Switch |
Auto high beam switch signal |
OFF or ON | OFF: Auto high beam switch off ON: Auto high beam switch on |
- |
| Turn Signal Switch (Right) |
Turn signal switch (right turn position) signal |
OFF or ON | OFF: Turn signal switch not in right turn position ON: Turn signal switch in right turn position |
- |
| Turn Signal Switch (Left) |
Turn signal switch (left turn position) signal |
OFF or ON | OFF: Turn signal switch not in left turn position ON: Turn signal switch in left turn position |
- |
| Cornering Light/Front Side Illuminate Light Switch |
Turn signal switch (full turn) signal |
OFF or ON | OFF: Turn signal switch not in left or right turn position ON: Turn signal switch in left or right full turn position |
- |
| Front Fog Light Switch |
Front fog light switch signal |
OFF or ON | OFF: Front fog light switch off ON: Front fog light switch on |
w/ Front Fog Light |
|
Rear Fog Light/Bad Weather Switch |
Rear fog light switch signal |
OFF or ON | OFF: Rear fog light switch off ON: Rear fog light switch on |
- |
| Automatic Light Equipped Info |
Automatic light control system specification information |
Unknown, With or Without |
Unknown: Specification not stored With: Automatic light control system equipped Without: Automatic light control system not equipped |
- |
| Bad Weather Mode Equipped Info |
Bad weather specification information |
Unknown, Without or With |
Unknown: Specification not stored Without: Bad weather specification not equipped With: Bad weather specification equipped |
Although the item is displayed on the GTS, it is not applicable to this vehicle. |
|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Hazard Flasher Switch | Hazard warning signal switch signal |
OFF or ON | OFF: Hazard warning signal switch off ON: Hazard warning signal switch on |
- |
| Lane Change Flashing Times Adjust |
Condition of the lane change flashing times |
OFF, 3, 4, 5, 6 or 7 | Customize setting displayed |
- |
|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Actual driven distance |
0 to 16777215 | Roughly the same as the actual driven distance |
- |
| Total Distance Traveled - Unit |
Actual driven distance unit |
km or mile | Displays the current actual driven distance unit |
- |
| Back-up Light Input Signal |
Back-up light input | OFF or ON |
OFF: Shift lever in any position other than R ON: Shift lever in R |
*2 |
| Back-up Light Fuse Shut Off Status |
Back-up light fuse shut off status |
OFF or ON | OFF: Fuse has no shut off history ON: Fuse has shut off history |
*2 |
| Back-up Light Fuse Shut Off Count |
Back-up light fuse shut off history |
0 to 255 | 0 |
*2 |
| Front Fog Light Input Signal |
Front fog light input |
OFF or ON | OFF: Front fog light is not input ON: Front fog light is input |
*1 |
| Front Fog Light Output Signal |
Front fog light output |
OFF or ON | OFF: Front fog light is not output ON: Front fog light is output |
*1 |
| Front Fog Light Output Current |
Front fog light current |
0 to 255 A | Below 0.4 A |
Front Fog light current when output is on*1 |
|
Front Fog Light Fuse Shut Off Status |
Front fog light fuse condition |
OFF or ON | OFF: Front fog light fuse not shut off ON: Front fog light fuse shut off |
*1 |
| Front Fog Light Fuse Shut Off Count |
Front fog light fuse shut off count |
0 to 255 | Front fog light fuse has no shut off count |
*1 |
- *1: w/ Fog Light
- *2: for HEV Model
ACTIVE TEST
HINT:
Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Enter the following menus:
(1) for Main Body: Body Electrical / Main Body / Active Test.
(2) for Combination Meter: Body Electrical / Combination Meter / Active Test.
(b) Perform the Active Test according to the display on the GTS.
Body Electrical > Main Body > Active Test|
Tester Display | Measurement Item |
Control Range | Diagnostic Note |
|---|---|---|---|
|
Headlight Relay / Light Power Supply Relay |
Headlights | OFF or ON |
- |
| High Beam Headlight |
High beam headlights |
OFF or ON | - |
|
Daytime Running Light | Daytime running lights |
OFF or ON | - |
|
Automatic High Beam Switch Light |
Auto high beam switch indicator light |
OFF or ON | - |
|
Dimmer Signal | Auto dimmer signal |
OFF or ON | State where circumference illumination is bright |
|
Rear Fog Light | Rear fog lights |
OFF or ON | Although this item is displayed on the GTS, it is not applicable to this vehicle. |
|
Front Fog Light | Front fog lights |
OFF or ON |
|
| Taillight / Clearance Light |
Taillights and clearance lights |
OFF or ON | - |
|
Tester Display | Measurement Item |
Control Range | Diagnostic Note |
|---|---|---|---|
|
Automatic High Beam Indicator (Green) |
Automatic high beam indicator light |
OFF or ON | - |
READ NEXT:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lighting System
DTC No. Detection Item
Link B124400
Light Sensor Circuit Malfunction
B243900 Headlight LH Circuit
B243
Light Sensor Circuit Malfunction (B124400)
DESCRIPTION The automatic light control sensor detects ambient light. The sensor creates an electrical signal based on the amount of light detected, and sends the signal to the main body ECU (multiple
Headlight LH Circuit (B243900,B243A00)
DESCRIPTION The light control LED ECU supplies internally boosted voltage to the light control LED ECU so that the current supplied to the LED is always maintained at a constant value.
These DTCs are
SEE MORE:
Inspection
INSPECTION
PROCEDURE
1. INSPECT ELECTRIC PARKING BRAKE SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the
table below.
Standard Resistance:
Tester Connection
Condition
Spec
Driver Side Power Window does not Operate with Power Window Master Switch
DESCRIPTION When the ignition switch is ON, the power window regulator motor assembly (for driver door) is operated by the multiplex network master switch assembly. The power window regulator motor assembly (for driver door) has motor, regulator and ECU functions. WIRING DIAGRAM
Click here CAUTIO
