Toyota Corolla Cross: Cylinder Head
READ NEXT:
PRECAUTION
HINT:
Any digits beyond the 0.01 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
When both standard and maximum or minimum valu
DISASSEMBLY CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced durin
INSPECTION PROCEDURE 1. INSPECT CYLINDER HEAD SUB-ASSEMBLY
(a) Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces where the cylinder head sub-assembly conta
SEE MORE:
ELECTRONIC CIRCUIT INSPECTION PROCEDURE
BASIC INSPECTION
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance measurements are standard values
measured at an ambient temperature of 20°C (68°F). Resistance measurements may be
inaccurate if measured at
INSPECTION PROCEDURE 1. INSPECT FUEL PRESSURE SENSOR
(a) Check the fuel pressure sensor output voltage.
(1) Apply 5 V between terminals 1 (VC) and 2 (E2).
NOTICE:
Be careful when connecting the leads as the fuel pressure sensor may be damaged if the leads are connected to the wrong
Precaution
Electronic Circuit Inspection Procedure
