Toyota Corolla Cross: Automatic High Beam System
Toyota Corolla Cross (2022-2024) Service Manual / ADAS & AD / Advanced Driver Assistance System / Automatic High Beam System
- Precaution
- Parts Location
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Automatic High Beam Switch Circuit
- Automatic High Beam Switch Indicator does not Come ON
READ NEXT:
Precaution
PRECAUTION
HANDLING PRECAUTIONS FOR FORWARD RECOGNITION CAMERA
(a) When replacing the forward recognition camera, always replace
it with a new one. If a forward recognition camera which was instal
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
w/ AFS
-
-
*1
HEADLIGHT ASSEMBLY LH
*2
HEADLIGHT ASSEMBLY RH
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the automatic high beam
system.
*: Use the GTS.
PROCEDURE
1.
VEHICLE BROUGHT TO WO
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT WINDSHIELD GLASS SUB-ASSEMBLY (for Cold Area Specification Vehicles)
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
A
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
When performing an inspection, make sure that "ACC Customize" is set to "ON" using the multi-display.
Click here
When "ACC Customize" is set to "ON" (ACC supply power enabled), the certification ECU (smart key ECU assembly) controls the ACC relay on and off. When
© 2020-2024 Copyright www.tcorollacross.com
