Toyota Corolla Cross: Using an anchor bracket (for top tether strap) (except for Puerto Rico)
■ Anchor brackets (for top tether strap)
Anchor brackets are provided for each rear seat.
Use anchor brackets when fixing the top tether strap.
- Anchor brackets
- Top tether strap
■ Fixing the top tether strap to the anchor bracket
Install the child restraint system in accordance to the operation manual enclosed with the child restraint system.
Rear outboard seats
1. Adjust the head restraint to the upmost position.
If the head restraint interferes with your child restraint system, and the head restraint can be removed, remove the head restraint.
2. Latch the hook onto the anchor bracket and tighten the top tether strap.
Make sure the top tether strap is securely latched. When installing the child restraint system with the head restraint being raised, be sure to have the top tether strap pass underneath the head restraint.
- Hook
- Top tether strap
Rear center seat
Latch the hook onto the anchor bracket and tighten the top tether strap.
Make sure the top tether strap is securely latched.
- Hook
- Top tether strap
■Laws and regulations pertaining to anchors
The LATCH system conforms to FMVSS225 or CMVSS210.2.
Child restraint systems conforming to FMVSS213 or CMVSS213 specifications can be used.
This vehicle is designed to conform to SAE J1819.
WARNING
■When installing a child restraint system
Observe the following precautions.
Failure to do so may result in death or serious injury.
- Firmly attach the top tether strap and make sure that the belt is not twisted.
- Do not attach the top tether strap to anything other than the anchor bracket.
- After securing a child restraint system, never adjust the seat.
- Follow all installation instructions provided by the child restraint system manufacturer.
- Outboard rear seats: When installing the child restraint system with the head restraint being raised, after the head restraint has been raised and then the anchor bracket has been fixed, do not lower the head restraint.
READ NEXT:
Using a top tether anchorage
(for Puerto Rico)
■ Top tether anchorages
Top tether anchorages are provided
for each rear seat.
Use top tether anchorages
when fixing the top strap.
Top tether anchorages
Top strap
■ Fixing the top strap to
Emergency assistance
Safety Connect
Safety Connect is a subscription-based telematics
service that uses Global
Positioning System (GPS)
data and embedded cellular
technology to provide
safety and security features
to subs
System components
Microphone
LED light indicators
"SOS" button
Services
Subscribers have the following
Safety Connect services available:
Automatic Collision Notification*
Helps drivers receive necessary
respo
SEE MORE:
Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground (P022011)
DESCRIPTION Refer to DTC P012011. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P022011 Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground
The output voltage of VTA2 is less than 2.05 V for 2 seconds or more (
Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 2 AIR FUEL RATIO SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 (HA1B) - 2 (+B)
20°C (68°F) 2 to 6 Ω
1 (H
