Toyota Corolla Cross: Registration
REGISTRATION
CAUTION / NOTICE / HINT
PROCEDURE
1. VIN (VEHICLE IDENTIFICATION NUMBER)
NOTICE:
The Vehicle Identification Number (VIN) must be written to a replacement ECM.
HINT:
The VIN is a 17-digit alphanumeric vehicle identification number. The GTS is required to register the VIN.
(a) DESCRIPTION
HINT:
This registration section consists of 2 parts: Read VIN and Write VIN.
(1) Read VIN: This procedure allows the VIN stored in the ECM to be read in order to confirm that the 2 VINs, provided with the vehicle and stored in the vehicle ECM, are the same.
(2) Write VIN: This procedure allows the VIN to be written to the ECM. If the ECM is replaced, or the ECM VIN and vehicle VIN do not match, the VIN can be registered, or overwritten in the ECM by following this procedure.
(b) READ VIN
(1) Confirm the vehicle VIN.
(2) Connect the GTS to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the GTS on.
(5) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Read.
Powertrain > Engine > Utility|
Tester Display |
|---|
| VIN |
(6) According to the display on the GTS, read the VIN stored in the ECM.
(c) WRITE VIN
(1) Confirm the vehicle VIN.
(2) Connect the GTS to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the GTS on.
(5) Enter the following menus: Powertrain / Engine / Utility / VIN / VIN Write.
Powertrain > Engine > Utility|
Tester Display |
|---|
| VIN |
(6) According to the display on the GTS, write the VIN to the ECM.
READ NEXT:
Initialization
INITIALIZATION Inspection After Repair Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation. Details on procedures required are indicated by an
Checking Monitor Status
CHECKING MONITOR STATUS The purpose of the monitor result (mode 06) is to allow access to the results of on-board diagnostic monitoring tests of specific components/systems that are not continuously m
Readiness Monitor Drive Pattern
READINESS MONITOR DRIVE PATTERN PURPOSE OF READINESS TESTS
The On-Board Diagnostic (OBD II) system is designed to monitor the performance of emission related components, and indicate any detected
SEE MORE:
Image from Camera for Parking Assist Monitor is Abnormal
DESCRIPTION
The display signal from the rear television camera assembly
is transmitted to the display.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced or operations that are
performed during vehicle inspection or maintenance, calibration of other sy
Lost Communication with ECM/PCM "A" Missing Message (U010087,...,U016387)
DESCRIPTION These DTCs are stored when the CAN communication system is malfunctioning.
DTC No. Detection Item
DTC Detection Condition Trouble Area
Memory U010087
Lost Communication with ECM/PCM "A" Missing Message
Diagnosis Condition:
IG voltage 8.5 V or
