Toyota Corolla Cross: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
for HEV Model:
Click here .gif)
for Gasoline Model:
Click here
HINT:
- Troubleshooting of the theft deterrent system is based on the premise that the power door lock control system and the wireless door lock control system are operating normally. Accordingly, before troubleshooting the theft deterrent system, first make certain that the power door lock control system and the wireless door lock control system are operating normally.
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom | Suspected Area |
Link |
|---|---|---|
|
Theft deterrent system cannot be set |
Refer to "Security Indicator Light Does not Blink" (for HEV Model ) |
|
|
Refer to "Security Indicator Light Does not Blink" (for Gasoline Model) |
| |
|
Refer to "Front Door Courtesy Switch Circuit" |
| |
|
Refer to "Rear Door Courtesy Switch Circuit" |
| |
|
Refer to "Back Door Courtesy Switch Circuit" |
| |
|
Front door lock with motor assembly |
| |
|
Rear door lock with motor assembly |
| |
|
Back door lock with courtesy light switch assembly |
| |
|
Refer to "Engine Hood Courtesy Switch Circuit" |
| |
|
Security indicator light does not blink when theft deterrent system is set |
Refer to "Security Indicator Light Does not Blink" (for HEV Model ) |
|
|
Refer to "Security Indicator Light Does not Blink" (for Gasoline Model) |
| |
|
Alarm sounding state cannot be canceled when ignition switch is turned to ON |
Refer to "Smart Key System (for Start Function, HEV Model)" |
|
|
Refer to "Smart Key System (for Start Function, Gasoline Model)" |
| |
|
Certification ECU (Smart key ECU assembly) |
- | |
| If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Theft deterrent system can be set even when door is open |
Refer to "Front Door Courtesy Switch Circuit" |
|
|
Refer to "Rear Door Courtesy Switch Circuit" |
| |
|
Refer to "Back Door Courtesy Switch Circuit" |
| |
|
If the symptom(s) still occur after the above areas are inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Theft deterrent system can be set even when engine hood is open |
Refer to "Engine Hood Courtesy Switch Circuit" |
|
|
Vehicle horns do not sound while theft deterrent system is in alarm sounding state |
Refer to "Horn Circuit" |
|
|
Security horn does not sound while theft deterrent system is in alarm sounding state |
Refer to "Security Horn Circuit" |
|
|
Low beams do not blink while theft deterrent system is in alarm sounding state |
Refer to "Lighting System (w/ AFS)" |
|
|
Refer to "Lighting System (w/o AFS)" |
| |
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Taillights do not blink while theft deterrent system is in alarm sounding state |
Refer to "Taillight Relay Circuit (w/ AFS)" |
|
|
Refer to "Taillight Relay Circuit (w/o AFS)" |
| |
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Hazard warning lights do not flash while theft deterrent system is in alarm sounding state |
Combination meter assembly |
- |
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Interior lights do not light up while theft deterrent system is in alarm sounding state |
Refer to "Interior Light Circuit" |
|
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Low beams blink even when theft deterrent system is not set |
Refer to "Lighting System (w/ AFS)" |
|
|
Refer to "Lighting System (w/o AFS)" |
| |
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Taillights blink even when theft deterrent system is not set |
Refer to "Taillight Relay Circuit (w/ AFS)" |
|
|
Refer to "Taillight Relay Circuit (w/o AFS)" |
| |
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Hazard warning lights flash even when theft deterrent system is not set |
Combination meter assembly |
- |
| If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
| |
|
Interiors light comes on even when theft deterrent system is not set |
Refer to "Interior Light Circuit" |
|
|
If the symptom(s) still occur after the above area is inspected and proved to be normal, replace the main body ECU (multiplex network body ECU) |
|
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY
(a) Remove the main body ECU (multiplex network body ECU) from the power distribution box assem
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
Engine Hood Courtesy Switch Circuit
DESCRIPTION The engine hood courtesy switch is built into the hood lock assembly. This switch turns on when the engine hood is closed and turns off when the engine hood is opened. WIRING DIAGRAM
CA
SEE MORE:
System Voltage (BATT) Circuit Short to Ground or Open (P056014)
DESCRIPTION Auxiliary battery power is supplied to the BATT terminal of the hybrid vehicle control ECU in order to store DTCs and freeze frame data. Even if the ignition switch is turned off, back-up power is supplied.
DTC No. Detection Item
DTC Detection Condition
Trouble Area
Vacuum Sensor
RemovalREMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 VACUUM HOSE
- -
- -
2 E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
89421
- - CAUTION / NOTICE / HINT
