Toyota Corolla Cross: Precaution
PRECAUTION
PRECAUTION FOR BULB REPLACEMENT
(a) Always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if the bulb is removed from the vehicle for a long time.
(b) Always replace a bulb with another bulb of the same wattage.
(c) If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
(d) Securely install the socket after bulb replacement. The lens may become cloudy or the light assembly may fill with water through gaps around the socket if it is not installed securely.
READ NEXT:
PARTS LOCATION ILLUSTRATION
*A w/ Fog Light
*B for Outer Rear View Mirror Type Side Turn Signal Light
*1 HEADLIGHT ASSEMBLY LH
- PARKING LIGHT BULB (for Bulb Type Clearance
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the lighting system.
*: Use the GTS.
PROCEDURE
1. VEHICLE BROUGHT TO WORKSHOP
NEXT
OPERATION CHECK AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/ Automatic Light Control System)
NOTICE: Make sure that the customize settings are set to default when performing the automatic light
SEE MORE:
DESCRIPTION
The power steering ECU assembly supplies a voltage of 5 V to the torque sensor
(electric power steering column sub-assembly) and monitors the voltage value of
the Hall IC inside the torque sensor (electric power steering column sub-assembly)
which changes in response to changes in
DESCRIPTION Refer to DTC P003012. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P2A0026 O2 Sensor Circuit Range/Performance Bank 1 Sensor 1 Signal Rate of Change Below Threshold
The calculated value for the air fuel ratio se
