Toyota Corolla Cross: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the lighting system.
- *: Use the GTS.
PROCEDURE
|
1. | VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
| 2. |
CUSTOMER PROBLEM ANALYSIS |
HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points for problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Driving conditions, weather conditions
How did it happen?
Problem symptoms
|
| 3. |
PRE-CHECK |
(a) Measure the auxiliary battery voltage with the ignition switch off.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
(b) Check the fuses and relays.
(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
|
| 4. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Using the GTS, check for CAN communication system DTCs.
- for HEV Model: Click here
.gif)
- for Gasoline Model: Click here
|
Result | Proceed to |
|---|---|
|
CAN DTCs are not output (for LED Type Parking Light without AFS) |
A |
| CAN DTCs are not output (for Bulb Type Parking Light) |
B |
| CAN DTCs are output |
C |
| B |
.gif) | GO TO STEP 6 |
| C |
| GO TO CAN COMMUNICATION SYSTEM
|
|
| 5. |
CHECK CXPI COMMUNICATION SYSTEM* |
(a) Use the GTS to check if the CXPI communication system is functioning normally.
Click here
OK:
CXPI communication system DTCs are not output.
| OK | | GO TO STEP 6 |
| NG | | GO TO CXPI COMMUNICATION SYSTEM |
| 6. |
CHECK FOR DTC* |
(a) Check for DTCs.
Body Electrical > Main Body > Trouble Codes|
Result | Proceed to |
|---|---|
|
Malfunction is duplicated but DTCs are not output |
A |
| Malfunction cannot be duplicated and DTCs are not output |
B |
| DTCs are output |
C |
| B |
| USE SIMULATION METHOD TO CHECK |
| C |
| GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
| 7. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
|
Result | Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table |
A |
| Fault is listed in Problem Symptoms Table |
B |
| B |
| GO TO PROBLEM SYMPTOMS TABLE |
|
| 8. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check.
Click here
(b) Terminals of ECU.
Click here
(c) Data List / Active Test.
Click here
(d) On-vehicle Inspection.
(e) Inspection.
|
| 9. |
ADJUST, REPAIR OR REPLACE |
|
| 10. |
CONFIRMATION TEST |
| NEXT | | END |
READ NEXT:
Operation Check
OPERATION CHECK AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (w/ Automatic Light Control System)
NOTICE: Make sure that the customize settings are set to default when performing the automatic light
Customize Parameters
CUSTOMIZE PARAMETERS CUSTOMIZE LIGHTING SYSTEM (EXT)
NOTICE:
When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
Before replacing the main body ECU (multiplex network body ECU) or certification ECU (smart key ECU assembly), refer to Registration.*1
*1: w/ Smart Key System
SEE MORE:
Operation Check
OPERATION CHECK STOP AND START SYSTEM OPERATION CHECK
HINT:
If the cable is disconnected from the auxiliary battery terminal, stop and start control is prohibited until refresh charge is completed.
In this case, let the vehicle idle to complete the refresh charge. The refresh charge is compl
VEHICLE CONTROL HISTORY (RoB)
VEHICLE CONTROL HISTORY (RoB) CHECK VEHICLE CONTROL HISTORY (AIR CONDITIONING SYSTEM) Body Electrical > Air Conditioner > Utility
Tester Display Vehicle Control History (RoB) Vehicle Control History
Code Tester Display
Measurement Item Diagnostic Note
X210F
