Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK

(a) When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), slip indicator light, VSC OFF indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.

HINT:

  • When the brake fluid level is low, the brake system warning light (red indicator) comes on.
  • If the skid control ECU stores any DTCs, the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator) or slip indicator light will come on. Also, in this state, if the vehicle is under the following conditions and the brake hold switch (electric parking brake switch assembly) is turned on, the brake hold operated indicator light blinks.
    • Vehicle Conditions:
      1. The driver door is closed.
      2. The driver seat belt is fastened.
  • If the warning lights and indicator lights do not illuminate or illuminate for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.

    Click here

    READ NEXT:

     VEHICLE CONTROL HISTORY (RoB)

    VEHICLE CONTROL HISTORY (RoB) DESCRIPTION Vehicle Control History (RoB) is a function that captures and stores ECU data when triggered by specific vehicle behavior. It may be possible to d

     Yaw Rate Sensor Circuit Voltage Out of Range (C00631C)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. The skid control ECU (brake actuator assembly) calibrates the sensitivity o

     Yaw Rate Sensor Circuit Intermittent (C00631F,C006396,C05201F,C052096,C11781F,C117896)

    DESCRIPTION The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. These DTCs are stored when the skid control ECU (brake actuator assembly) r

    SEE MORE:

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Sliding Roof System DTC No. Detection Item DTC Output from Link B234149 Sliding Roof Motor Internal Electronic Failure Main Body B234407 Sliding Roof Position Mechanical Failure Main Body B23457E Sliding

     VEHICLE CONTROL HISTORY (RoB)

    VEHICLE CONTROL HISTORY (RoB) HINT: The Vehicle Control History stores the history of the reject function and system protection operations. The number of occurrences, date and distance are stored in batches for each item. CHECK VEHICLE CONTROL HISTORY (CONTINUOUSLY VARIABLE TRANSAX

    © 2020-2025 Copyright www.tcorollacross.com