Toyota Corolla Cross: Low Beam LH Circuit Voltage Out of Range (B24441C,B24451C)
DESCRIPTION
The BIN resistance is equipped for the purpose of correcting variances in brightness (luminous flux) when the light control LED ECU is energizing the LED with a constant current to illuminate it.
Also, it monitors the voltage applied to the BIN resistance in order to detect abnormalities in the energizing current and thereby detect malfunctions.
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
B24441C | Low Beam LH Circuit Voltage Out of Range | Detection condition:
- Ignition switch is to ON, low beam headlights illuminated
Malfunction status:
- Headlight assembly LH (BIN resistance) malfunction
- Open/short in headlight assembly LH (BIN resistance) circuit
Malfunction duration:
| Headlight assembly LH |
B24451C | Low Beam RH Circuit Voltage Out of Range | Detection condition:
- Ignition switch is to ON, low beam headlights illuminated
Malfunction status:
- Headlight assembly RH (BIN resistance) malfunction
- Open/short in headlight assembly RH (BIN resistance) circuit
Malfunction duration:
| Headlight assembly RH |
CAUTION / NOTICE / HINT
NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CXPI communication malfunctions before troubleshooting this symptom.
Click here
PROCEDURE
Body Electrical > Main Body > Clear DTCs
NEXT |
| |
NOTICE:
Turn the ignition switch ON and wait for at least 10 seconds or more.
Body Electrical > Main Body > Trouble Codes
Result | Proceed to |
B243900, B243A00, B24441C or B24451C is output |
A |
B243900, B243A00, B24441C and B24451C are not output |
B |
B |
| USE SIMULATION METHOD TO CHECK |
READ NEXT:
DESCRIPTION These DTCs are stored if a CAN communication malfunction occurs between the main body ECU (multiplex network body ECU) and other ECUs.
DTC No. Detection Item
DTC Detection Condi
DESCRIPTION The steering sensor receives the turn signal switch information and controls the turn signal lights. WIRING DIAGRAM
PROCEDURE
1.
READ VALUE USING GTS (a) Read the Data List a
DESCRIPTION The steering sensor receives the following switch information:
Light control switch in DRL OFF*1, TAIL, HEAD, AUTO position
Dimmer switch in high, low or high flash (pass) position
SEE MORE:
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If
multiple suspected areas are listed, the potential causes of the symptoms are
listed in order of probability in the "Suspected Area" column of the table.
Check each symptom by
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55606 -
- -
2 FRONT NO. 1 CONSOLE BOX INSERT
58816D -
- -
3 FRONT NO. 2 CONSOLE B