Toyota Corolla Cross: Key-off Operation Function Operates even if Operating Conditions are not Satisfied
DESCRIPTION
When the front doors are closed, each power window regulator motor assembly can be operated for approximately 45 seconds after the ignition switch is turned from ON to off by receiving operation permission signals from the main body ECU (multiplex network body ECU). However, when approximately 45 seconds have elapsed, or the driver door or front passenger door is opened within approximately 45 seconds of the ignition switch being turned off, the power window regulator motor assemblies stop operating.
During auto operation, when 45 seconds have elapsed and key-off operation is prohibited, the power window stops immediately.
CAUTION / NOTICE / HINT
NOTICE:
- The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.
Click here
.gif)
- If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click here
- Before replacing the main body ECU (multiplex network body ECU), refer to Registration.
- for HEV Model:
Click here
- for Gasoline Model:
Click here
- for HEV Model:
PROCEDURE
|
1. | CHECK MANUAL UP / DOWN FUNCTION |
(a) Check that the manual up and down functions using the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH or RH door) can operate the power windows.
Click here
OK:
Manual up and down functions are normal.
| NG | .gif) | GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) |
|
.gif)
| 2. |
CHECK REMOTE UP / DOWN FUNCTION |
(a) Check that the remote up and down functions using the multiplex network master switch assembly can operate all of the power windows.
Click here
OK:
Remote up and down functions are normal.
| NG | | GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table) |
|
| 3. |
CHECK KEY-OFF OPERATION FUNCTION |
(a) Check the key-off operation function.
Click here
|
Result | Proceed to |
|---|---|
|
Power window can be operated even after opening driver door or front passenger door within approximately 45 seconds of ignition switch being turned off |
A |
| Power window can be operated even after approximately 45 seconds have elapsed since ignition switch was turned off (for All Doors) |
B |
| Power window can be operated even after approximately 45 seconds have elapsed since ignition switch was turned off (for Driver Door or Front Passenger Door) |
C |
| Power window can be operated even after approximately 45 seconds have elapsed since ignition switch was turned off (for Rear LH Door or Rear RH Door) |
D |
| B |
| REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| C |
| REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door) |
| D |
| REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door) |
|
| 4. |
READ VALUE USING GTS (Main Body) |
(a) Read the Data List according to the display on the GTS.
Body Electrical > Main Body > Data List|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
FR Door Courtesy Switch Status |
Front door courtesy light switch assembly (for RH) signal |
Close or Open | Close: Front door RH closed Open: Front door RH open |
- |
| FL Door Courtesy Switch Status |
Front door courtesy light switch assembly (for LH) signal |
Close or Open | Close: Front door LH closed Open: Front door LH open |
- |
|
Tester Display |
|---|
| FR Door Courtesy Switch Status |
|
FL Door Courtesy Switch Status |
OK:
On the GTS screen, ON or OFF is displayed accordingly.
| OK | | REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| NG | | GO TO LIGHTING SYSTEM (Proceed to Front Door Courtesy Switch Circuit) |
READ NEXT:
Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the jam protection function may be trigg
Auto Down Operation does not Fully Open Power Window (Catch Protection Function is Activated)
DESCRIPTION If a door glass does not slide smoothly or a power window regulator motor assembly or door window regulator sub-assembly does not operate smoothly, the catch protection function may be tri
Jam Protection Function does not Operate
DESCRIPTION This symptom may occur for any of the power windows.
The jam protection function operates within a specified range during the manual up or auto up operation. CAUTION / NOTICE / HINT
NOTI
SEE MORE:
High Pressure Fuel Pump Circuit Open (P123513)
DESCRIPTION The high-pressure direct injection fuel system consists of a spill control valve, check valve, fuel relief valve, fuel pressure sensor (for high pressure side), fuel pump assembly (for high pressure side) and direct fuel injector assemblies. The spill control valve adjusts the return vol
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the telematics system.
*: Use the GTS.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
C
