Toyota Corolla Cross: Installation
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
|
Procedure | Part Name Code |
.png) |
.png) |
.png) | |
|---|---|---|---|---|---|
|
1 | FRONT SEATBACK EDGE PROTECTOR |
71587 | - |
- | - |
|
2 | FRONT SEATBACK FELT |
79977A | - |
- | - |
|
3 | LUMBAR SUPPORT ADJUSTER ASSEMBLY |
72760D | - |
- | - |
|
Procedure | Part Name Code |
|
|
| |
|---|---|---|---|---|---|
|
4 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD |
- | - |
- | - |
|
5 | FRONT SEAT HEADREST SUPPORT |
71931 |
|
- | - |
|
Procedure | Part Name Code |
|
|
| |
|---|---|---|---|---|---|
|
6 | SEPARATE TYPE FRONT SEATBACK ASSEMBLY |
- | - |
- | - |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
- | - |
|
Procedure | Part Name Code |
|
|
| |
|---|---|---|---|---|---|
|
7 | FRONT SEAT INNER CUSHION SHIELD |
71862 | - |
- | - |
|
8 | FRONT SEAT CUSHION SHIELD |
71812D | - |
- | - |
|
9 | FRONT SEAT FRONT CUSHION SHIELD |
71868N | - |
- | - |
|
Procedure | Part Name Code |
|
|
| |
|---|---|---|---|---|---|
|
10 | SEPARATE TYPE FRONT SEATBACK COVER |
71073S | - |
- | - |
|
11 | FRONT SEAT ASSEMBLY |
- | - |
- | - |
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
.png)
PROCEDURE
1. INSTALL FRONT SEATBACK EDGE PROTECTOR
2. INSTALL FRONT SEATBACK FELT
3. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY
4. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
5. INSTALL FRONT SEAT HEADREST SUPPORT
|
|
Click here |
6. INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
7. INSTALL FRONT SEAT INNER CUSHION SHIELD
8. INSTALL FRONT SEAT CUSHION SHIELD
9. INSTALL FRONT SEAT FRONT CUSHION SHIELD
10. CONNECT SEPARATE TYPE FRONT SEATBACK COVER
11. INSTALL FRONT SEAT ASSEMBLY
Click here .gif)
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 FRONT SEAT ASSEMBLY
- -
- -
2 FRONT SEAT FRONT CUSHION
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: Slide Switch
SEE MORE:
Engine Hood Courtesy Switch Circuit
DESCRIPTION The engine stop and start ECU detects whether the engine hood is open or closed based on a signal received from the engine hood courtesy switch built into the hood lock with courtesy light switch assembly.
The engine stop and start ECU prohibits starting of the engine by stop and start
A/F (O2) Sensor Signal Biased/Stuck Lean Bank 1 Sensor 1 Circuit Current Above Threshold (P219519,P219524,P219618,P219623)
DESCRIPTION Refer to DTC P003012. Click here
HINT: Although the DTC titles say O2 sensor, these DTCs relate to the air fuel ratio sensor (sensor 1).
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P219519 A/F (O2) Sensor Signal Biased/Stuck Le
