Toyota Corolla Cross: How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the wireless charging system.
PROCEDURE
| 1. |
VEHICLE BROUGHT TO WORKSHOP |
|
.gif)
| 2. |
CUSTOMER PROBLEM ANALYSIS |
HINT:
- In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
- Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.
- The following 5 items are important points for problem analysis:
What
Vehicle model, system name
When
Date, time, occurrence frequency
Where
Road conditions
Under what conditions?
Driving conditions, weather conditions
How did it happen?
Problem symptoms
|
| 3. |
INSPECT AUXILIARY BATTERY |
(a) Measure the auxiliary battery voltage with the ignition switch off.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.
(b) Check the fuses and relays.
(c) Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
|
| 4. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here .gif)
|
Result | Proceed to |
|---|---|
|
Fault is not listed in Problem Symptoms Table |
A |
| Fault is listed in Problem Symptoms Table |
B |
| B |
.gif) | GO TO STEP 6 |
|
| 5. |
OVERALL ANALYSIS AND TROUBLESHOOTING |
(a) Operation Check.
Click here
(b) Terminals of ECU.
Click here
|
| 6. |
ADJUST, REPAIR OR REPLACE |
|
| 7. |
CONFIRMATION TEST |
| NEXT | | END |
READ NEXT:
Operation Check
OPERATION CHECK WIRELESS CHARGING SYSTEM OPERATION CHECK
*a Charging Tray
*b Charging Area
*c Mobile Wireless Charger Switch
*d Indicator Light (Green/Amber)
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU CHECK MOBILE WIRELESS CHARGER CRADLE ASSEMBLY
Terminal No. (Symbol) Terminal Description
Condition Specified Condition
I213-1 (PGND) - Body ground
Grou
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 ECM
*2 NO. 1 ENGINE ROOM RELAY BLOCK AND NO. 1 ENGINE ROOM JUNCTION BLOCK
- IG2 NO. 1 RELAY - EFI-MAIN NO. 2 RELAY - INJ FUSE
*3 FUEL TANK ASSEMBLY
*4 FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
- FUEL PUMP (for Low Press
Brake Pedal Position Sensor Supply Voltage Circuit Voltage Out of Range (C05621C,...,P157A62)
DESCRIPTION
The brake pedal stroke sensor assembly sends the brake pedal
stroke distance to the skid control ECU inside the brake actuator assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
DTC Output from
