Toyota Corolla Cross: Freeze Frame Data
Toyota Corolla Cross (2022-2024) Service Manual / Vehicle Exterior / Door / Hatch / Power Back Door System / Freeze Frame Data
FREEZE FRAME DATA
FREEZE FRAME DATA
(a) Whenever a DTC is detected, the multiplex network door ECU stores the current vehicle state as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Enter the following menus: Body Electrical / Back Door / Trouble Codes.
Body Electrical > Back Door|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
Total distance traveled |
0 to 16777215 | Same as actual total distance traveled |
For the unit, refer to "Total Distance Traveled - Unit" |
|
Total Distance Traveled - Unit |
Total Distance Traveled - Unit |
km or mile | km: km mile: mile | - |
CLEAR FREEZE FRAME DATA
NOTICE:
Clearing the DTCs will also clear the Freeze Frame Data.
(a) Clear the DTCs and Freeze Frame Data.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Back Door System
DTC No. Detection Item
Link B222049
Back Door Motor Internal Electronic Failure
B222631 PBD Unit Pulse Sensor
VEHICLE CONTROL HISTORY (RoB)
VEHICLE CONTROL HISTORY (RoB)
NOTICE:
If the vehicle or vehicle controls are operated (for example, during initial inspection when the vehicle is brought in for repair) before vehicle control histo
SEE MORE:
Cold Start Ignition Timing Performance (P050B00)
MONITOR DESCRIPTION A monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). If certain conditions are met, a DTC is stored after the engine idles for 13 seconds (2 trip detection logic).
This DTC is designed to monitor the ignition timing at c
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR CENTER SEAT OUTER BELT ASSEMBLY
(a) Before installing the rear center seat outer belt assembly, check the ELR function.
NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled
© 2020-2024 Copyright www.tcorollacross.com
