DATA LIST / ACTIVE TEST
DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
(a) Read the Data List according to the display on the GTS.
Chassis > Rear Camera > Data List
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
Total Distance Traveled |
Total distance traveled |
0 to 16777215 |
Same as actual total distance traveled |
For the unit, refer to "Total Distance Traveled - Unit" |
Total Distance Traveled - Unit |
Total distance traveled unit |
km or mile |
km: km mile: mile |
- |
Steering Angle |
Steering angle |
-3276.8 to 3276.7 deg |
Steering left: Changes positively continuously Steering right: Changes negative continuously |
- |
Vehicle Speed |
Vehicle speed |
0 to 655.35 km/h |
Equivalent to actual vehicle speed |
- |
EPS Steering Angle Value |
Calculate the current EPS rudder angle value |
-3276.8 to 3276.7 deg |
Steering left: Changes positively continuously Steering right: Changes negative continuously |
- |
Target Steering Angle Value (SBW) |
Calculate the current target steering angle value |
-3276.8 to 3276.7 deg |
Steering left: Changes positively continuously Steering right: Changes negative continuously |
- |