Toyota Corolla Cross: Customize Parameters
CUSTOMIZE PARAMETERS
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
- These buzzers should be on for safe driving. Perform this procedure only if it is necessary to set the buzzer to off (disabled).
CUSTOMIZE SEAT BELT WARNING SYSTEM
HINT:
The following items can be customized.
(a) Customizing with the GTS
(1) Select the setting by referring to the table below.
Warning|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| Driver Seatbelt Warning Buzzer Function |
Enables sounding of the driver seat belt warning buzzer |
ON | $00:OFF,$01:ON |
Combination meter assembly |
|
Passenger Seatbelt Warning Buzzer Function |
Enables sounding of the front passenger seat belt warning buzzer |
ON | $00:OFF,$01:ON |
Combination meter assembly |
|
Rear Right Seatbelt Warning Buzzer Function |
Function to sound the rear RH seat belt warning buzzer |
ON | $00:OFF,$01:ON |
Combination meter assembly |
|
Rear Left Seatbelt Warning Buzzer Function |
Function to sound the rear LH seat belt warning buzzer |
ON | $00:OFF,$01:ON |
Combination meter assembly |
|
Rear Center Seatbelt Warning Buzzer Function |
Function to sound the rear center seat belt warning buzzer |
ON | $00:OFF,$01:ON |
Combination meter assembly |
HINT:
These settings are only valid when the vehicle is driven at 20 km/h (12 mph) or more.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the info
Terminals Of Ecu
TERMINALS OF ECU CHECK POWER DISTRIBUTION BOX ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
(a) Remove the main body ECU (multiplex network body ECU). Click here
*1 Power
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whethe
SEE MORE:
Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range (P03652A)
DESCRIPTION Refer to DTC P036511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P03652A Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range
Diagnosis condition:
Engine cranking
Abnormal condition:
LTA (Lane Tracing Assist)
LTA functions
When driving on a road with
clear lane lines with the
dynamic radar cruise control
operating, lane lines and preceding
and surrounding vehicles
are detected using the
front camera and radar sensor,
and the steering wheel is
operated to maintain the vehicle's
lane position.
