Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Airbag ECU (G Sensor 2) General Checksum Failure (B116541)

Toyota Corolla Cross (2022-2025) Service Manual / Vehicle Interior / Supplemental Restraint Systems / Airbag System / Airbag ECU (G Sensor 2) General Checksum Failure (B116541)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Test Mode / Check Mode

B116541

Airbag ECU (G Sensor 2) General Checksum Failure

Airbag ECU assembly malfunction

Airbag ECU assembly

Comes on

Does not apply to test/check mode

CAUTION / NOTICE / HINT

NOTICE:

After replacing the airbag ECU assembly, refer to work procedure.

Click here

PROCEDURE

1.

CHECK DTC

(a) Turn the ignition switch to ON, and wait for at least 60 seconds.

(b) Clear the DTCs.

Body Electrical > SRS Airbag > Clear DTCs

(c) Turn the ignition switch off.

(d) Turn the ignition switch to ON, and wait for at least 60 seconds.

(e) Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes

Result

Proceed to

B116541 is output

A

B116541 is not output

B
A

REPLACE AIRBAG ECU ASSEMBLY

B

USE SIMULATION METHOD TO CHECK

    READ NEXT:

     Right Side Restraints Sensor 5 / Left Side Restraints Sensor 5 Signal Compare Failure (B166A62)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode B166A62 Right Side Restraints Sensor 5 / Left Side Restr

     Lost Communication with Brake System Control Module "A" Missing Message (U012987,U023A87)

    DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Test Mode / Check Mode U012987 Lost Communication with Brake System Control Mod

     SRS Warning Light Remains ON

    DESCRIPTION The SRS warning light is located in the combination meter assembly. When the SRS is normal, the SRS warning light comes on for approximately 6 seconds after the ignition switch is turned

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL) Procedure Part Name Code 1 FAN WITH MOTOR ASSEMBLY - - - - 2 INLET HYBRID RADIATOR HOSE G922H - - - 3 NO. 1 WATER BY-PASS HOSE 16261G - - -

     Light Sensor Circuit Malfunction (B124400)

    DESCRIPTION The automatic light control sensor detects ambient light. The sensor creates an electrical signal based on the amount of light detected, and sends the signal to the main body ECU (multiplex network body ECU). The main body ECU (multiplex network body ECU) turns on or off the headlights a

    © 2020-2025 Copyright www.tcorollacross.com