Toyota Corolla Cross: Acn Call End
ACN CALL END
ACN CALL END
This function terminates the ACN (Automatic Collision Notification)
to the telematics provider. After a collision in which the DCM receives "Collision
Detection Signal", the vehicle will send the emergency call notification to the
telematics provider until the emergency call cancellation utility has been run,
or the mobilephone battery (if equipped) is depleted. Use the emergency call cancellation
utility to stop the ACN call.
NOTICE:
The mobilephone battery must not be replaced while an ACN call is
in progress.
(a) Enter the following menus:
Body Electrical > Telematics > Utility
|
Tester Display
|
|
Emergency Call Cancellation
|
(b) Follow the instructions on the GTS.
READ NEXT:
CUSTOMIZE PARAMETERS
CUSTOMIZE TELEMATICS SYSTEM
(a) Customizing with the GTS.
NOTICE:
When the customer requests a change in a function, first make sure that
the function can be customized
INITIALIZATION
RESET BACK-UP BATTERY CONDITION
HINT:
If the back-up battery (mobilephone battery) has been replaced,
it is necessary to perform the Reset Backup Battery Condition procedure.
(a)
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed i
SEE MORE:
DESCRIPTION Refer to DTC P012011. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Note
P022011 Throttle/Pedal Position Sensor/Switch "B" Circuit Short to Ground
The output voltage of VTA2 is less than 2.05 V for 2 seconds or more (
DESCRIPTION
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Memory
Note
C060B12
Left Electric Parking Brake Actuator Control Circuit
Short to Battery
Diagnosis Condition:
