Toyota Corolla Cross: Precaution
PRECAUTION
TROUBLESHOOTING PRECAUTION
NOTICE:
- Since the brake lines are critical safety related parts, be sure to disassemble and inspect the components if a brake fluid leak is found. If any abnormalities are found, replace the component with a new one.
- When removing brake components, cover the brake line connections to prevent foreign matter such as dust or dirt from entering the lines.
- Do not allow brake fluid on any painted vehicle body surface. If brake fluid leaks onto any painted surface, immediately wash it off.
- Do not damage or deform the brake lines during the removal and installation procedures.
- When installing a brake line or flexible hose, ensure that they are free from twists or kinks.
- Do not deform the bracket or vehicle body when connecting a brake line and flexible hose.
- If the metal end of a flexible hose does not fit into the groove on the bracket, twist the hose slightly to insert it.
- Flexible hoses must be kept free from shock absorber oil, grease, etc.
- When installing a brake line to a plastic clamp, ensure that the brake line is not loose or pinched.
- Do not reuse any clips or plastic clamps removed from a flexible hose.
- After installing a brake line or flexible hose, ensure that they do not interfere with any other components or the vehicle body.
DISCONNECTING AND CONNECTING FLEXIBLE HOSE AND BRAKE LINE
(a) Disconnecting:
|
*a |
Disconnecting |
|
*b |
Connecting |
|
*c |
Hold |
|
*d |
Turn |
|
*e |
Flexible Hose |
|
*f |
Brake Line |
|
*g |
Clip |
(1) Hold the flexible hose with a wrench and disconnect the brake line using a union nut wrench without deforming the brake line.
(2) Remove the clip and disconnect the flexible hose.
(b) Connecting:
(1) Secure the flexible hose with a new clip. Be sure to securely install the clip.
(2) Connect the brake line using a union nut wrench without deforming the brake line.
CONNECTING BRAKE LINE AND WAY
(a) While supporting the way to prevent deformation of the brake line, connect the brake line to the way with a union nut wrench.
|
*a |
Hold |
|
*b |
Turn |
|
*c |
Way |
(b) While supporting the way to prevent deformation of the brake line, install the bolt to secure the way to the vehicle body.
READ NEXT:
System Diagram
SYSTEM DIAGRAM
HINT:
See the layout drawing to confirm the locations and tightening torque
of flexible hoses and brake lines.
*A
for HEV Model
-
-
Removal
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
PRECAUTION
-
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR LOCK WITH MOTOR ASSEMBLY LH
(a) Check the door lock motor operation. (1) Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor.
OK:
Measurement Condition
Specified Condition
Auxi
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT: Using the GTS to read the Data List allows the values or states o
