Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: Precaution

PRECAUTION

NOTES FOR TELEVISION CAMERA ASSEMBLY

(a) Notes for the television camera assembly

(1) The rear view monitor system may not function properly if subjected to a severe blow by any hard object.

(2) Do not scrub the camera lens. Scrubbing may scratch the camera lens and affect the image.

(3) The cover part of the camera is made of resin. Prevent organic solvents, waxes, bond removing solvents or glass coating from adhering to the cover. If such material adheres to the cover, clean it off immediately and wash it with water.

(4) Exposing the camera to a sudden temperature change may affect proper functioning of the camera.

(5) A clear image may not appear if the camera is dirty with snow, mud, etc. In that case, wash it with water and wipe off the lens. Use a detergent to remove dirt if necessary.

(6) When washing the vehicle with a high-pressure washer, do not spray water on the television camera assembly or surrounding area. High-pressure water can damage the camera.

(b) Images may be unclear even in normal conditions if:

(1) Electrical devices are used in the cabin (noise may occur in the image).

(2) Accessories that generate radio waves have been installed (noise may occur in the image).

(3) The outer mirror switch assembly is operated (noise may occur in the image).

(4) The display of radio and display receiver assembly is cold (the image immediately after turning the ignition switch to ON may be blurred or darker than normal).

(5) The camera lens is dirty with snow, mud, etc.

(6) A strong beam of light, such as a sunbeam or headlight, hits the camera.

(7) It is too dark around the camera (at night etc.).

(8) The ambient temperature around the camera is either too high or too low.

(9) The vehicle is tilted at a steep angle.

(10) The television camera assembly lens is scratched.

(11) The television camera assembly lens has drops of water on it or the humidity is high.

(12) When the camera is used under fluorescent lights, sodium lights, or mercury lights etc., the lights and the illuminated area may appear to flicker.

    READ NEXT:

     Parts Location

    PARTS LOCATION ILLUSTRATION *1 REAR TELEVISION CAMERA ASSEMBLY - - ILLUSTRATION *1 RADIO AND DISPLAY RECEIVER ASSEMBL

     System Diagram

    SYSTEM DIAGRAM

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the rear view monitor system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP

    SEE MORE:

     Inspection

    INSPECTION PROCEDURE 1. INSPECT FRONT POWER SEAT SWITCH (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Slide Switch Tester Connection Condition Specified Condition q7-4 - q7-6 Slide sw

     Steering Angle Sensor (C1297)

    DESCRIPTION The 4WD ECU assembly receives signals from the steering sensor, and thereby detects the steering angle of the steering wheel assembly to determine when the vehicle is turning. When an abnormal signal is received from the steering sensor, the 4WD ECU assembly stores DTC C1297.

    © 2020-2024 Copyright www.tcorollacross.com