Toyota Corolla Cross: Passenger Seat Occupant Classification Sensor "C" Component Internal Failure (B00C296)
DESCRIPTION
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Warning Indicate | Test Mode / Check Mode |
B00C296 | Passenger Seat Occupant Classification Sensor "C" Component Internal Failure |
Rear occupant classification sensor LH malfunction |
Rear occupant classification sensor LH (Front seat cushion spring sub-assembly RH)* |
Comes on | Does not apply to test/check mode |
- *: The rear occupant classification sensor LH is built into the front seat cushion spring sub-assembly RH.
PROCEDURE
(a) Clear the DTCs stored in memory.
Body Electrical > SRS Airbag > Clear DTCs
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ON, and wait for at least 60 seconds.
NEXT |
| |
(a) Check for DTCs.
Body Electrical > SRS Airbag > Trouble Codes
Result | Proceed to |
B00C296 is output | A |
B00C296 is not output |
B |
HINT:
Codes other than DTC B00C296 may be output at this time, but they are not related to this check.
A |
| REPLACE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY RH |
B |
| USE SIMULATION METHOD TO CHECK |
READ NEXT:
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B179312 Load Sensor for Occupant Detection System Circui
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B179316 Load Sensor for Occupant Detection System Circui
DESCRIPTION
DTC No. Detection Item
DTC Detection Condition Trouble Area
Warning Indicate Test Mode / Check Mode
B179317 Load Sensor for Occupant Detection System Circui
SEE MORE:
DESCRIPTION
The CVT fluid temperature sensor converts the fluid temperature into a resistance
value which is detected by the TCM.
The sensor resistance changes with the CVT fluid temperature. As the temperature
rises, the sensor resistance decreases. The TCM applies voltage to the temperature
BRAKE
INSPECT BRAKE LINE PIPES AND HOSES
HINT:
Work in a well-lighted area. Turn the front wheels fully to the right or left
before beginning the inspection.
(a) Using a mirror, check the entire circumference and length of the brake lines
and hoses for:
Damage
Wear
Deformation
C