Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY
(a) Connect the GTS to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the GTS on.
(d) Enter the following menus: Powertrain / Hybrid Control / Data List / Accelerator Position Sensor No. 1 Voltage %, Accelerator Position Sensor No. 2 Voltage %.
Powertrain > Hybrid Control > Data List|
Tester Display |
|---|
| Accelerator Position Sensor No.1 Voltage % |
|
Accelerator Position Sensor No.2 Voltage % |
(e) Read the Data List.
|
Tester Display | Accelerator Pedal Condition |
Specified Condition |
|---|---|---|
|
Accelerator Position Sensor No. 1 Voltage % |
Not depressed | 10 to 22% |
|
Fully depressed | 52 to 90% | |
|
Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) |
Value changes progressively | |
|
Accelerator Position Sensor No. 2 Voltage % |
Not depressed | 24 to 40% |
|
Fully depressed | 68 to 99% | |
|
Not depressed → Fully depressed → Not depressed (Accelerator pedal should be operated slowly) |
Value changes progressively |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55606 -
- -
Installation
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 ACCELERATOR PEDAL SENSOR ASSEMBLY
78110K
SEE MORE:
Sliding Roof Switch Assembly
RemovalREMOVAL CAUTION / NOTICE / HINT COMPONENTS (REMOVAL)
Procedure Part Name Code
1 MAP LIGHT ASSEMBLY
81260A
- - PROCEDURE
1. REMOVE MAP LIGHT ASSEMBLY Click here
InspectionINSPECTION PROCEDURE
1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT
Rear Seat Belt Warning Light Malfunction
DESCRIPTION The power distribution box assembly sends a signal indicating a rear seat belt status when the ignition switch is ON to the main body ECU (multiplex network body ECU) via CXPI communication.
The main body ECU (multiplex network body ECU) sends a signal indicating the rear door courtesy
