Toyota Corolla Cross: On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY
(a) With the ignition switch to ON and the wheels not contacting the ground, operate the electric parking brake switch (electric parking brake switch assembly) to check the condition of the rear wheels when the electric parking brake is operating and not operating.
OK:|
Assembly Status |
Condition of Rear Wheels |
|---|---|
|
Lock |
Rear wheels cannot be rotated |
|
Release |
Rear wheels can be rotated |
(b) Pull the electric parking brake switch (electric parking brake switch assembly) to the lock side for approximately 1 second and check that the parking brake indicator light (red) turns on.
(c) Push the electric parking brake switch (electric parking brake switch assembly) to the release side for approximately 1 second and check that the parking brake indicator light (red) turns off.
(d) At this time, check that the brake warning light (yellow indicator) does not turn on.
READ NEXT:
Removal
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
Procedure
Part Name Code
1
PRECAUTION
-
Inspection
INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY LH
(a) Parking brake actuator assembly LH operation inspection
(1) Apply voltage to the terminals of the parking brake ac
Installation
INSTALLATION
CAUTION / NOTICE / HINT
COMPONENTS (INSTALLATION)
Procedure
Part Name Code
1
PARKING BRAKE ACTUATOR ASSEMB
SEE MORE:
VEHICLE CONTROL HISTORY (RoB)
VEHICLE CONTROL HISTORY (RoB)
DESCRIPTION
Vehicle Control History (RoB) is a function that captures and stores
ECU data when triggered by specific vehicle behavior.
If the customer states that the engine stalled or will not start, it
may be possible to diagnose the cause of the malfu
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT HORN RELAY ASSEMBLY (a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
3 - 5 Auxiliary
