Toyota Corolla Cross: Front Window Fogging
DESCRIPTION
If the windshield frequently fogs up even though the air conditioning system is operating, the following factors may be the cause.
|
Symptom | Factor |
|---|---|
|
Windshield frequently fogs up |
|
PROCEDURE
| 1. |
PERFORM REFRIGERANT SHORTAGE CHECK |
(a) Perform the Utility according to the display on the GTS.
Body Electrical > Air Conditioner > Utility|
Tester Display |
|---|
| Refrigerant Gas Volume Check |
(b) Check that the following conditions are met and perform the refrigerant shortage check according to the display on the GTS.
Measurement Condition:|
Item | Condition |
|---|---|
|
A/C switch | On |
|
Ambient temperature* |
0 to 49°C (32 to 120°F) |
|
Blower speed | HI |
*: If the ambient temperature is not within the range shown, do not perform this check.
|
Result | Amount of Refrigerant |
|---|---|
|
Refrigerant correct | Correct |
|
Refrigerant shortage |
Insufficient |
OK:
"Refrigerant correct" is displayed on the GTS.
| NG | .gif) | CHARGE SYSTEM WITH REFRIGERANT |
|
.gif)
| 2. |
CHECK OPERATION |
(a) Press the front defroster switch on the air conditioning control assembly and check that the air outlet mode changes to DEF mode.
OK:
The air outlet mode changes to DEF mode.
| OK | | INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET |
| NG | | GO TO DTC B14037F |
READ NEXT:
Blower Motor does not Operate
DESCRIPTION If air does not flow from the front registers after the blower switch on the air conditioning control assembly is operated, the following factors may be the cause.
Symptom Factor
Weak Blower Output
DESCRIPTION If the airflow from the front registers is weak regardless of the blower speed setting displayed on the air conditioning control assembly, the following factors may be the cause.
Sym
Recirculated/Fresh Air Modes Switch without User Input
DESCRIPTION If recirculation/fresh mode changes unintentionally and without permission, the following causes are possible.
Symptom Factor
Recirculation/fresh mode changes without
SEE MORE:
Brake System Control Module "A" System Voltage System Voltage High (C137BA3)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the
skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function
prohibits ABS operation.
This DTC is stored when the +BS terminal voltage deviates due
to a malfunction in a power supply or chargin
Steering Angle Sensor Supply Voltage Circuit Circuit Short to Ground or Open
(C14FE14)
DESCRIPTION
This DTC is stored when the skid control ECU (brake actuator
assembly) receives a +B line open signal from the steering sensor.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C14FE14
Steering Angle S
