Toyota Corolla Cross: Customize Parameters
CUSTOMIZE PARAMETERS
CUSTOMIZE WIPER AND WASHER SYSTEM (w/ Rear Wiper System)
NOTICE:
- When the customer requests a change in a function, first make sure that the function can be customized.
- Be sure to make a note of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
HINT:
The following items can be customized.
(a) Select the setting by referring to the table below.
Wiper|
Tester Display | Description |
Default | Setting |
ECU |
|---|---|---|---|---|
| R Wiper Stop Function at Back Door/Trunk Lid Open |
Function to enable the back door open linked rear wiper suspend function |
Available | $00:Enable,$01:Disable |
Main body ECU (Multiplex network body ECU) |
|
Rear Wiper Washer Function |
Function to enable the rear washer linked rear wiper operation function |
Available | $00:Enable,$01:Disable |
Main body ECU (Multiplex network body ECU) |
|
Rear Wiper with Reverse Setting |
Function to enable the R shift position linked rear wiper operation function |
Not Available | $00:Disable,$02:1 time,$03:Continuation |
Main body ECU (Multiplex network body ECU) |
HINT:
Changes to the customize settings will not be applied until the ignition switch is turned off then ON.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
NOTICE:
Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*1
for HEV Model:
Click here
for Gasoline Model:
Click here
Terminals Of Ecu
TERMINALS OF ECU CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND POWER DISTRIBUTION BOX ASSEMBLY
*1 Power Distribution Box Assembly
*2 Main Body ECU (Multiplex Network Body ECU)
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a p
SEE MORE:
Right Front Wheel Speed Sensor Supply Voltage Circuit Short to Ground or Open
(C14E314)
DESCRIPTION
Refer to DTC C050612
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
DTC Output from
Note
C14E314
Right Front Wheel Speed Sensor Supply Voltage Circuit
Diagnosis System
DIAGNOSIS SYSTEM OBD II (except Mexico Models)
When troubleshooting OBD II (On-Board Diagnostics) vehicles, the GTS (complying with SAE J1978) must be connected to the DLC3 (Data Link Connector 3) of the vehicle. Various data in the vehicle's ECM (Engine Control Module) can be then read.
OBD II
