Toyota Corolla Cross Owners & Service Manuals

Toyota Corolla Cross: System Description

SYSTEM DESCRIPTION

GENERAL

The windshield deicer system uses thin heater wires attached to the inside of the windshield glass to help deice the window surface more quickly. An indicator light illuminates while the system is operating. This system automatically turns off after approximately 15 minutes.

NOTICE:

If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. In this case, the windshield deicer system may not operate.

FUNCTION OF MAIN COMPONENT

Component

Outline

Front Wiper Deicer Switch

Sends signals to the air conditioning control assembly to operate the windshield deicer system.

Air Conditioning Control Assembly

Sends windshield deicer activation request signals to the air conditioning amplifier assembly.

Air Conditioning Amplifier Assembly

Sends windshield deicer activation request signals to the DEICER relay.

DEICER Relay

Receives windshield deicer activation request signals from the air conditioning amplifier assembly and supplies power to the windshield deicer wire (windshield glass).

Windshield Deicer Wire (Windshield Glass)

Receives power from the DEICER relay and heats the windshield deicer wire (windshield glass).

    READ NEXT:

     How To Proceed With Troubleshooting

    CAUTION / NOTICE / HINT HINT: Use the following procedure to troubleshoot the windshield deicer system. *: Use the GTS. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT

     Operation Check

    OPERATION CHECK CHECK WINDSHIELD DEICER SYSTEM (a) Turn the ignition switch to ON. (b) Check that the windshield deicer wire (windshield glass) becomes warm by operating the front wiper deicer switch

     Problem Symptoms Table

    PROBLEM SYMPTOMS TABLE NOTICE: If the auxiliary battery voltage becomes low, auxiliary battery load control will operate in order to ensure sufficient power is supplied to the power steering system. I

    SEE MORE:

     Engine Coolant Temperature Sensor 1 Circuit Short to Ground (P011511)

    DESCRIPTION A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor. Refer to DTC P011011. Clic

     Stop And Start System Cancel Switch Assembly

    InspectionINSPECTION PROCEDURE 1. INSPECT ECO RUN CANCEL SWITCH ASSEMBLY (COMBINATION SWITCH ASSEMBLY) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition I61-8 (ERC)

    © 2020-2025 Copyright www.tcorollacross.com PT NL