Toyota Corolla Cross: Removal
REMOVAL
CAUTION / NOTICE / HINT
COMPONENTS (REMOVAL)
|
Procedure | Part Name Code |
.png) |
.png) |
.png) | |
|---|---|---|---|---|---|
|
1 | RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
- |
|
- | - |
|
2 | WASHER INLET SUB-ASSEMBLY |
85301 | - |
- | - |
|
3 | AIR CONDITIONER PRESSURE SENSOR |
88719A |
|
- | - |
|
● | Non-reusable part |
- | - |
PROCEDURE
1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Click here
.gif)
2. REMOVE WASHER INLET SUB-ASSEMBLY
3. REMOVE AIR CONDITIONER PRESSURE SENSOR
|
*a | Turn |
*b | Hold |
(1) Disconnect the connector.
(2) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor as shown in the illustration.
NOTICE:
Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT COMPONENTS (INSTALLATION)
Procedure Part Name Code
1 AIR CONDITIONER PRESSURE SENSOR
88719A
- -
Precaution
PRECAUTION DO NOT HANDLE REFRIGERANT IN AN ENCLOSED AREA OR NEAR AN OPEN FLAME
*a Charging Cylinder
ALWAYS WEAR EYE PROTECTION BE CAREFUL NOT TO GET LIQUID REFRIGERANT IN YOUR EYES O
SEE MORE:
Right Rear Wheel Speed Sensor Circuit Short to Ground or Open (C051214)
DESCRIPTION
Refer to DTC C051212
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
MIL
DTC Output from
Note
C051214
Right Rear Wheel Speed Sensor Circuit Short to Ground
Power Steering Torque Sensor "A" Signal Compare Failure (C151162,C151187,C151262,C151287)
DESCRIPTION
The power steering ECU assembly supplies a voltage of 5 V to the torque sensor
(electric power steering column sub-assembly) and monitors the voltage value of
the Hall IC inside the torque sensor (electric power steering column sub-assembly)
which changes in response to changes in
© 2020-2025 Copyright www.tcorollacross.com
