Toyota Corolla Cross: Introduction
READ NEXT:
GENERAL INFORMATION
A large number of ECU controlled systems are used in this vehicle. In general,
ECU controlled systems are considered to be very intricate, requiring a high
level of techn
ELECTRONIC CIRCUIT INSPECTION PROCEDURE
BASIC INSPECTION
(a) WHEN MEASURING RESISTANCE OF ELECTRONIC PARTS
(1) Unless otherwise stated, all resistance measurements are standard values
measured at
SEE MORE:
DESCRIPTION The BIN resistance is equipped for the purpose of correcting variances in brightness (luminous flux) when the light control LED ECU is energizing the LED with a constant current to illuminate it.
Also, it monitors the voltage applied to the BIN resistance in order to detect abnormalitie
DESCRIPTION If the temperature of the air that blows from the left and right front registers differs, even though the same temperature is set for both sides, the following factors may be the cause.
Symptom Factor
Temperature of outlet air is cooler on left or right side
(Whe
General Information
Low Beam LH Circuit Voltage Out of Range (B24441C,B24451C)
