Toyota Corolla Cross: Child restraint systems
Before installing a child
restraint system in the vehicle,
there are precautions
that need to be observed,
different types of child
restraint systems, as well as
installation methods, etc.,
written in this manual.
Use a child restraint system
when riding with a small child
that cannot properly use a
seat belt. For the child's
safety, install the child
restraint system to a rear seat.
Be sure to follow the installation
method that is in the operation
manual enclosed with
the restraint system.
Table of contents
Points to remember
Child restraint system
When using a child restraint system
Child restraint system compatibility
for each seating position
(for Puerto Rico)
Child restraint system installation
method
- Fixed with a seat belt
- Fixed with a child restraint
LATCH anchor (except for
Puerto Rico)
- Fixed with an ISOFIX lower anchorage (for Puerto Rico)
- Using an anchor bracket (for
top tether strap) (except for
Puerto Rico)
- Using a top tether anchorage
(for Puerto Rico)
READ NEXT:
The laws of all 50 states of the
U.S.A. as well as Canada now
require the use of child restraint
systems.
Prioritize and observe the
warnings, as well as the laws
and regulations for child
restra
■ When installing a child
restraint system to a front
passenger seat
For the safety of a child, install a
child restraint system to a rear
seat. When installing a child
restraint system to a front p
■ Child restraint system compatibility
for each seating
position
Compatibility of each seating
position with child restraint systems
displays the type
of child restraint systems that
can be used and
SEE MORE:
DESCRIPTION
Refer to DTC C050612
Click here
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C14E314
Right Front Wheel Speed Sensor Supply Voltage Circuit
Short to Ground or Open
An open or short i
INSPECTION
PROCEDURE
1. INSPECT SHIFT LOCK CONTROL ECU (w/ Smart Key System)
HINT:
If the results of the following inspections are as specified but a malfunction
has occurred, replace the shift lock control unit assembly.
(a) Inspect wire harness:
(1) Disconnect the shift lock con