Toyota Corolla Cross: Before driving
Observe the following
before starting off in the
vehicle to ensure safety of
driving.
Floor mat
Use only floor mats designed
specifically for vehicles of the
same model and model year as
your vehicle. Fix them securely
in place onto the carpet.
1. Insert the retaining hooks
(clips) into the floor mat eyelets.
2. Turn the upper knob of each
retaining hook (clip) to secure
the floor mats in place.
Always align the marks A.
The shape of the retaining hooks
(clips) may differ from that shown in
the illustration.
WARNING
Observe the following precautions.
Failure to do so may cause the
driver's floor mat to slip, possibly
interfering with the pedals while
driving. An unexpectedly high
speed may result or it may
become difficult to stop the vehicle.
This could lead to an accident,
resulting in death or serious
injury.
■When installing the driver's
floor mat
- Do not use floor mats designed
for other models or different
model year vehicles, even if
they are Toyota Genuine floor
mats.
- Only use floor mats designed
for the driver's seat.
- Always install the floor mat
securely using the retaining
hooks (clips) provided.
- Do not use two or more floor
mats on top of each other.
- Do not place the floor mat bottom-
side up or upside-down.
■Before driving
- Check that the floor mat is
securely fixed in the correct
place with all the provided
retaining hooks (clips). Be especially
careful to perform this
check after cleaning the floor.
- With the engine stopped and
the shift lever in P, fully depress
each pedal to the floor to make
sure it does not interfere with
the floor mat.
READ NEXT:
For safe driving, adjust the
seat and mirror to an appropriate
position before driving.
Correct driving posture
Adjust the angle of the seatback
so that you are sitting
straight up and so that yo
Make sure that all occupants
are wearing their seat
belts before driving the
vehicle.
WARNING
Observe the following precautions
to reduce the risk of injury in the
event of sudden braking, sudden
swer
Extend the shoulder belt so
that it comes fully over the
shoulder, but does not come
into contact with the neck or
slide off the shoulder.
Position the lap belt as low as
possible over the hi
SEE MORE:
DATA LIST / ACTIVE TEST
READ DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are
reference values. Do not depend solely on these reference values when deciding whether
a part is faulty or not.
HINT:
Using the GTS to read the Data List allows the va
DISPOSAL CAUTION / NOTICE / HINT
CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE
1. PRECAUTION
CAUTIO