Toyota Corolla Cross: A/C Switch Indicator does not Turn On
DESCRIPTION
If none of the switch indicators on the air conditioning control assembly illuminate, the following factors may be the cause.
Symptom | Factor |
A/C switch indicator does not illuminate |
- Air conditioning amplifier assembly malfunction
- Air conditioning control assembly malfunction
- A/C switch malfunction
- A/C switch indicator malfunction (including when indicator turned off without switch operation)
- Servo motor initialization (incomplete)
- Mechanical locking of damper and damper link
- Refrigerant pressure is extremely low
- Low detected ambient temperature (including thermistor assembly malfunction)
|
PROCEDURE
1. |
CHECK MALFUNCTION STATUS |
(a) Check the malfunction status of switch indicators on the air conditioning control assembly.
Result | Proceed to |
Indicators are not always illuminated |
A |
Indicators are not illuminated only immediately after starting the engine |
B |
B |
| GO TO INITIALIZATION |
A |
| |
(a) Read the Data List according to the display on the GTS.
Body Electrical > Air Conditioner > Data List
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
Ambient Temperature Sensor |
Thermistor assembly | Min.: -327.68°C (-557.82°F)
Max.: 327.67°C (-621.81°F) |
Actual ambient temperature displayed |
Ambient temperature sensor (thermistor assembly) circuit malfunction |
Body Electrical > Air Conditioner > Data List
Tester Display |
Ambient Temperature Sensor |
OK:
The value displayed is 0°C (32°F) or higher.
OK |
| INSPECT REFRIGERANT PRESSURE WITH MANIFOLD GAUGE SET |
NG |
| GO TO OTHER DIAGNOSIS PROCEDURE (Ambient Temperature Display System) |
READ NEXT:
DESCRIPTION If the cooling effect of the air conditioning system is weak, the following factors may be the cause.
Symptom Factor
Cooling effectiveness is poor
Cooling respon
DESCRIPTION If the air conditioning system cannot be operated using the air conditioning control assembly, the following factors may be the cause.
Symptom Factor
Air conditioning syste
DESCRIPTION If the windshield frequently fogs up even though the air conditioning system is operating, the following factors may be the cause.
Symptom Factor
Windshield frequently fogs
SEE MORE:
SYSTEM DESCRIPTION
OPERATION OF OUTER REAR VIEW MIRROR INDICATOR AND RCTA BUZZER (BLIND
SPOT MONITOR BUZZER)
(a) Initial check
(1) When the blind spot monitor system is turned on with the ignition
switch to ON, the outer rear view mirror indicators on the outer rear view mirror
assembly ill
TERMINALS OF ECU
CHECK 4WD ECU ASSEMBLY
(a) Measure the voltage and resistance of the connector.
Terminal No. (Symbol)
Terminal Description
Condition
Specified Condition
O201-6 (CANH) - O201-5 (CANL)
CAN communication line